Skip to contentSkip to conversation

Bug: AR928x not working on 2.6.31.x

DISCUSSION [email protected] 1 participant 1 message Oct 7, 2009

lore
Share & tools
lore
#0 lore raw

I am using Archlinux on my Acer Extensa 7630EZ and realize that my wireless-device which is an

Atheros Communications Inc. AR928X Wireless Network Adapter (PCI-Express) (rev 01)

according to lspci works very well using arch-stock kernel 2.6.30 and is not working any longer when using the 2.6.31.1 or 2.6.31.2 kernel from Arch's testing repository.

When using the 2.6.30 kernel (wlan is working very well), I get the following dmesg-output:
[bernhard@wallaby ~]$ dmesg |grep ath
ath9k 0000:05:00.0: enabling device (0000 -> 0002)
ath9k 0000:05:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
ath9k 0000:05:00.0: setting latency timer to 64
phy0: Selected rate control algorithm 'ath9k_rate_control'
Registered led device: ath9k-phy0::radio
Registered led device: ath9k-phy0::assoc
Registered led device: ath9k-phy0::tx
Registered led device: ath9k-phy0::rx

When upgrading to 2.6.31.x, i receive the following output:
[bernhard@wallaby ~]$ dmesg |grep ath
ath9k 0000:05:00.0: enabling device (0000 -> 0002) ath9k 0000:05:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 ath9k 0000:05:00.0: setting latency timer to 64 ath9k 0000:05:00.0: PCI INT A disabled

As I see it, the device is recognized and instantly disabled again. The device cannot be brought up too using ifconfig.

I am quite clueless what do do aside from reporting the bug here as suggested in the original Arch-bugreport (http://bugs.archlinux.org/task/16413)

If any further information is helpful, I will of course happily try to provide it.

Bernhard

Signature · 2 lines
GRATIS für alle GMX-Mitglieder: Die maxdome Movie-FLAT!
Jetzt freischalten unter http://portal.gmx.net/de/go/maxdome01