scsi: add hpsa driver for HP Smart Array controllers.
Subsystems (2)
PATCH 17/17 scsi: add hpsa driver for HP Smart Array controllers.
From: "Stephen M. Cameron" <[email protected]>
Add hpsa driver for HP Smart Array controllers.
This driver supports a subset of HP Smart Array Controllers. It is a SCSI alternative to the cciss driver.
[[email protected]: avoid helpful cleanup patches]
[[email protected]: make device attrs static]
[[email protected]: msleep() does set_current_state() itself]
Signed-off-by Stephen M. Cameron <[email protected]>
Signed-off-by Mike Miller <[email protected]>
Cc Jens Axboe <[email protected]>
Cc James Bottomley <[email protected]>
Signed-off-by Alex Chiang <[email protected]>
Signed-off-by Andrew Morton <[email protected]>
---
drivers/scsi/Kconfig | 10 drivers/scsi/Makefile | 1 drivers/scsi/hpsa.c | 3531 ++++++++++++++++++++++++++++++++++++++ drivers/scsi/hpsa.h | 273 ++ drivers/scsi/hpsa_cmd.h | 326 +++ 5 files changed, 4141 insertions(+)
drivers/scsi/Kconfig renamed from drivers/scsi/Kconfig~scsi-add-hpsa-driver-for-hp-smart-array-controllers +10 -0
@@ -388,6 +388,16 @@ config BLK_DEV_3W_XXXX_RAID Please read the comments at the top of <file:drivers/scsi/3w-xxxx.c>. +config SCSI_HPSA + tristate "HP Smart Array SCSI driver" + depends on PCI && SCSI + help + This driver supports HP Smart Array Controllers (circa 2009). + It is a SCSI alternative to the cciss driver, which is a block + driver. Anyone wishing to use HP Smart Array controllers who + would prefer the devices be presented to linux as SCSI devices, + rather than as generic block devices should say Y here. + config SCSI_3W_9XXX tristate "3ware 9xxx SATA-RAID support" depends on PCI && SCSI
drivers/scsi/Makefile renamed from drivers/scsi/Makefile~scsi-add-hpsa-driver-for-hp-smart-array-controllers +1 -0
@@ -91,6 +91,7 @@ obj-$(CONFIG_SCSI_BFA_FC) += bfa/ obj-$(CONFIG_SCSI_PAS16) += pas16.o obj-$(CONFIG_SCSI_T128) += t128.o obj-$(CONFIG_SCSI_DMX3191D) += dmx3191d.o +obj-$(CONFIG_SCSI_HPSA) += hpsa.o obj-$(CONFIG_SCSI_DTC3280) += dtc.o obj-$(CONFIG_SCSI_SYM53C8XX_2) += sym53c8xx_2/ obj-$(CONFIG_SCSI_ZALON) += zalon7xx.o
drivers/scsi/hpsa.c new file +3531 -0
2,977 lines not on this page · raw message
drivers/scsi/hpsa.h new file +273 -0
273 lines not on this page · raw message
drivers/scsi/hpsa_cmd.h new file +326 -0
326 lines not on this page · raw message
The rest of this diff is not shown. View the raw message.
_
Part of the diff is not shown here. View the raw message.