Skip to contentSkip to conversation

execve signal reset

PATCH Colin Watson 2 participants 2 messages Jan 5, 2010 1 message not in the archive Man-pages: manual pages for Linux -- Sections 2, 3, 4, 5, and 7

lore
Share & tools
lore
#0 lore raw

Using man-pages 3.23 on Ubuntu lucid, I recently had cause to look up what happens to signal handlers across execve(). The execve(2) manual page contains the following sentence:

The dispositions of any signals that are being caught are reset to being ignored.

As it happened, though, the signal I'm interested in right now defaults to "terminate process", so I found this statement ambiguous, and looked up POSIX, which says "Signals set to be caught by the calling process image shall be set to the default action in the new process image".

How about the following patch?

man2/execve.2 +2 -1
index 0ea50db..11bec18 100644
@@ -120,7 +120,8 @@ All process attributes are preserved during an
 except the following:
 .IP *
 The dispositions of any signals that are being caught are
-reset to being ignored.
+reset to the default action
+.RB ( signal (7)).
 .IP *
 Any alternate signal stack is not preserved
 .RB ( sigaltstack (2)).

Thanks,

Signature · 5 lines
Colin Watson                                       [[email protected]]
--
To unsubscribe from this list: send the line "unsubscribe linux-man" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

A message that is not in the archive (sent off-list or not yet received): [email protected]

#2 lore raw

Hello Colin,

Quoted 7 lines · Colin Watson

Using man-pages 3.23 on Ubuntu lucid, I recently had cause to look up what happens to signal handlers across execve(). The execve(2) manual page contains the following sentence:

 The dispositions of any signals that are being caught are reset to being ignored.

Quoted 6 lines

As it happened, though, the signal I'm interested in right now defaults to "terminate process", so I found this statement ambiguous, and looked up POSIX, which says "Signals set to be caught by the calling process image shall be set to the default action in the new process image".

How about the following patch?

Obviously correct, and applied for 2.34.

Thanks,

Michael

Quoted 21 lines
man2/execve.2 +0 -0
index 0ea50db..11bec18 100644
@@ -120,7 +120,8 @@ All process attributes are preserved during an

 except the following:
 .IP *
 The dispositions of any signals that are being caught are

man2/execve.2 +2 -1
-reset to being ignored.
+reset to the default action
+.RB ( signal (7)).

 .IP *
 Any alternate signal stack is not preserved
 .RB ( sigaltstack (2)).

Thanks,

--
Colin Watson                                       [[email protected]]

Signature · 7 lines
Michael Kerrisk
Linux man-pages maintainer; http://www.kernel.org/doc/man-pages/
Author of "The Linux Programming Interface" http://blog.man7.org/
--
To unsubscribe from this list: send the line "unsubscribe linux-man" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html