SystemAce not ready under XUPV2P and XUPV5
Hi,
I have a problem with accessing the cf-card under u-boot. I use the XUPV2P with a ppc + microblaze and the XUPV5 with mb only. None of my eval-bords work with cf. This is the error-message under the xupv2p with ppc:
t001-ppc405:/# fatinfo ace 0:0 **** ACE CompactFlash not found. **** SystemACE not ready. ** Can't read from device 0 **
** Unable to use ace 0:0 for fatinfo **
After searching with google I found this:
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/archive/2008/10/msg00144.html
It seems this is the same prob.
This are the defines of my xilinx-ppc405-generic.h:
/*SystemACE*/
#define CONFIG_SYSTEMACE
#define CONFIG_DOS_PARTITION
#define CONFIG_SYS_SYSTEMACE_BASE 0x83600000
#define CONFIG_SYS_SYSTEMACE_WIDTH 16
#define SYSTEMACE_CONFIG_FPGA
#define DEBUG_SYSTEMACE
Under microblaze i have the same problems.
Greets,
Oliver
Signature · 2 lines
GRATIS f?r alle GMX-Mitglieder: Die maxdome Movie-FLAT! Jetzt freischalten unter http://portal.gmx.net/de/go/maxdome01