Skip to contentSkip to conversation

Suggest feature removal: CONFIG_SERIAL_SOFTWARE_FIFO

U-Boot Stefan Roese 2 participants 2 messages Sep 14, 2010

lore
Share & tools
lore
#0 lore raw

Hi,

upon revisiting the PPC4xx UART driver, I stumbled (again) over the CONFIG_SERIAL_SOFTWARE_FIFO feature. As it seems this feature is only implemented for PPC4xx and is not used in any mainline board ports. Frankly I never really understood why such a "feature" should be used. So I'm asking if anybody is really caring for this feature. If not, I'll send a patch to remove this stuff completely.

Any comments?

Cheers,
Stefan

--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de

#1 lore raw

Dear Stefan Roese,

Quoted 9 lines · In message <[email protected]> you wrote:

upon revisiting the PPC4xx UART driver, I stumbled (again) over the CONFIG_SERIAL_SOFTWARE_FIFO feature. As it seems this feature is only implemented for PPC4xx and is not used in any mainline board ports. Frankly I never really understood why such a "feature" should be used. So I'm asking if anybody is really caring for this feature. If not, I'll send a patch to remove this stuff completely.

Any comments?

ACK for removal.

Best regards,

Wolfgang Denk

Signature · 4 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
When all else fails, read the instructions.