Skip to contentSkip to conversation

move async raid6 test to lib/Kconfig.debug

PATCH New Dan Williams 1 participant 1 message Oct 8, 2010

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 move async raid6 test to lib/Kconfig.debug

The prompt for "Self test for hardware accelerated raid6 recovery" does not belong in the top level configuration menu. All the options in crypto/async_tx/Kconfig are selected and do not depend on CRYPTO. Kconfig.debug seems like a reasonable fit.

Cc Herbert Xu <[email protected]>
Cc David Woodhouse <[email protected]>
---
 crypto/async_tx/Kconfig |   13 -------------
 lib/Kconfig.debug       |   13 +++++++++++++
 2 files changed, 13 insertions(+), 13 deletions(-)
crypto/async_tx/Kconfig +0 -13
index 5de2ed1..1b11abb 100644
@@ -24,19 +24,6 @@ config ASYNC_RAID6_RECOV
 	select ASYNC_PQ
 	select ASYNC_XOR
 
-config ASYNC_RAID6_TEST
-	tristate "Self test for hardware accelerated raid6 recovery"
-	depends on ASYNC_RAID6_RECOV
-	select ASYNC_MEMCPY
-	---help---
-	  This is a one-shot self test that permutes through the
-	  recovery of all the possible two disk failure scenarios for a
-	  N-disk array.  Recovery is performed with the asynchronous
-	  raid6 recovery routines, and will optionally use an offload
-	  engine if one is available.
-
-	  If unsure, say N.
-
 config ASYNC_TX_DISABLE_PQ_VAL_DMA
 	bool
 
lib/Kconfig.debug +13 -0
index 1b4afd2..0deaf81 100644
@@ -1150,6 +1150,19 @@ config ATOMIC64_SELFTEST
 
 	  If unsure, say N.
 
+config ASYNC_RAID6_TEST
+	tristate "Self test for hardware accelerated raid6 recovery"
+	depends on ASYNC_RAID6_RECOV
+	select ASYNC_MEMCPY
+	---help---
+	  This is a one-shot self test that permutes through the
+	  recovery of all the possible two disk failure scenarios for a
+	  N-disk array.  Recovery is performed with the asynchronous
+	  raid6 recovery routines, and will optionally use an offload
+	  engine if one is available.
+
+	  If unsure, say N.
+
 source "samples/Kconfig"
 
 source "lib/Kconfig.kgdb"