printf in u-boot cannot support %f
Hi,
The codes below:
...
double result1 = 3.14;
printf("result1:%f\n", result1);// error
....
turn out:
result1:%f
How can I get the correct result? Thanks a lot!The U-boot version is:
=> ver
U-Boot 2008.10 (Jul 15 2009 - 21:56:05) MPC512X
I wan to a little more complex program in standalone mode in u-boot. Is it possilbe to port g-libc to u-boot standalone mode?
Tanks.
Best regards,
Michael Franklin
Dear "ITechnology",
Quoted 8 lines · In message <[email protected]> you wrote:
The codes below:
... double result1 = 3.14; printf("result1:%f\n", result1);// error .... turn out: result1:%f
Yes, this is to be expected.
Quoted 1 line
How can I get the correct result? Thanks a lot!
Youcannot. We do not use nor support any FP operations in U-Boot.
Quoted 1 line
I wan to a little more complex program in standalone mode in u-boot. Is it possilbe to port g-libc to u-boot standalone mode?
Everything is possible, assuming you throw enough manpower at it.
The real question however is if this makes sense. Usually, in such situations it does not. You might find it more efficient to boot into some OS instead.
Best regards,
Wolfgang Denk
Signature · 6 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de NOTE: The Most Fundamental Particles in This Product Are Held Together by a "Gluing" Force About Which Little is Currently Known and Whose Adhesive Power Can Therefore Not Be Permanently Guaranteed.