staging: olpc_dcon: remove noinit module variable

This came from Jordan's original 2007 gxfb_dcon commit. I've never seen or heard of it actually being used. Presumably it was once useful for skipping hardware initialization when reloading the module over and over during driver development..

Signed-off-by Andres Salomon <[email protected]>

---
 drivers/staging/olpc_dcon/olpc_dcon.c |    7 ++-----
 1 files changed, 2 insertions(+), 5 deletions(-)

(quoted diff) +0 -0

b/drivers/staging/olpc_dcon/olpc_dcon.c index 750fe50..cf4b454 100644

drivers/staging/olpc_dcon/olpc_dcon.c +2 -5

@@ -36,9 +36,6 @@
 static int resumeline = 898;
 module_param(resumeline, int, 0444);
 
-static int noinit;
-module_param(noinit, int, 0444);
-
 /* Default off since it doesn't work on DCON ASIC in B-test OLPC
 board */ static int useaa = 1;
 module_param(useaa, int, 0444);

@@ -90,7 +87,7 @@ static int dcon_hw_init(struct dcon_priv *dcon, int
 is_init) }
 	}
 
-	if (ver < 0xdc02 && !noinit) {
+	if (ver < 0xdc02) {
 		/* Initialize the DCON registers */
 
 		/* Start with work-arounds for DCON ASIC */

@@ -106,7 +103,7 @@ static int dcon_hw_init(struct dcon_priv *dcon,
 int is_init) i2c_smbus_write_word_data(client, 0x3b, 0x002b);
 		i2c_smbus_write_word_data(client, 0x41, 0x0101);
 		i2c_smbus_write_word_data(client, 0x42, 0x0101);
-	} else if (!noinit) {
+	} else {
 		/* SDRAM setup/hold time */
 		i2c_smbus_write_word_data(client, 0x3a, 0xc040);
 		i2c_smbus_write_word_data(client, 0x41, 0x0000);

Hi Greg,

Did you see these? I haven't seen any emails about them being merged into the staging tree yet..