Skip to contentSkip to conversation

mfd: Simulate active high IRQs with wm831x

DISCUSSION Dan Carpenter 2 participants 2 messages Sep 21, 2011

lore
Share & tools
lore
#0 lore raw

Hi Mark,

Smatch complains about d71820b8a8fbe9 "mfd: Simulate active high IRQs with wm831x"

drivers/mfd/wm831x-irq.c +522 wm831x_irq_thread(67)

	error: buffer overflow 'wm831x->gpio_level' 16 <= 56
   518                  /* Simulate an edge triggered IRQ by polling the input
   519                   * status.  This is sucky but improves interoperability.
   520                   */
   521                  if (primary == WM831X_GP_INT &&
   522                      wm831x->gpio_level[i - WM831X_IRQ_GPIO_1]) {
                            ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
   523                          ret = wm831x_reg_read(wm831x, WM831X_GPIO_LEVEL);
   524                          while (ret & 1 << (i - WM831X_IRQ_GPIO_1)) {
   525                                  handle_nested_irq(wm831x->irq_base + i);
   526                                  ret = wm831x_reg_read(wm831x,
   527                                                        WM831X_GPIO_LEVEL);
   528                          }
   529                  }

We're inside a for loop over ARRAY_SIZE(wm831x_irqs) which has 58 elements (so "i" is 0-57) and we subtract WM831X_IRQ_GPIO_1 (1) which gives us a max of 56. The ->gpio_level[] array only has 16 elements so we're reading beyond the end of the array.

In wm831x_irq_set_type() it only sets the first 11 elements of the ->gpio_level[] array. Perhaps something similar is needed here. I don't know the code well enough to say.

regards,
dan carpenter

#1 lore raw
Quoted 7 lines · Dan Carpenter
   518                  /* Simulate an edge triggered IRQ by polling the input
   519                   * status.  This is sucky but improves interoperability.
   520                   */
   521                  if (primary == WM831X_GP_INT &&
   522                      wm831x->gpio_level[i - WM831X_IRQ_GPIO_1]) {
                            ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Quoted 7 lines

We're inside a for loop over ARRAY_SIZE(wm831x_irqs) which has 58 elements (so "i" is 0-57) and we subtract WM831X_IRQ_GPIO_1 (1) which gives us a max of 56. The ->gpio_level[] array only has 16 elements

In wm831x_irq_set_type() it only sets the first 11 elements of the ->gpio_level[] array. Perhaps something similar is needed here. I don't know the code well enough to say.

There's no need for any additional checks, the check for the primary IRQ ensures that we know we're dealing with a GPIO IRQ.