Skip to contentSkip to conversation

eg20t: Fix fallback handling

PATCH New Alan Cox 1 participant 1 message Nov 8, 2011

Subsystems (2)
lore
Share & tools
lore

Alan Cox

author
#0 lore raw

PATCH 1/1 eg20t: Fix fallback handling

From: Alan Cox <[email protected]>

The 8250 PCI driver was updated to be smart about the EG20T devices. If the right driver is included the kernel 8250 driver skips these ports and they are driven in native mode. If they are not then it should drive them as 8250 ports.

Unfortunately the patch to do this forgot to set the setup method so instead in this specific instance the kernel instead jumps to fishkill.

Add the setup pointers.

---

 drivers/tty/serial/8250_pci.c |    9 +++++++++
 1 files changed, 9 insertions(+), 0 deletions(-)
drivers/tty/serial/8250_pci.c +9 -0
index 3abeca2..55677b9 100644
@@ -1558,46 +1558,55 @@ static struct pci_serial_quirk pci_serial_quirks[] __refdata = {
 		.vendor         = PCI_VENDOR_ID_INTEL,
 		.device         = 0x8811,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = PCI_VENDOR_ID_INTEL,
 		.device         = 0x8812,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = PCI_VENDOR_ID_INTEL,
 		.device         = 0x8813,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = PCI_VENDOR_ID_INTEL,
 		.device         = 0x8814,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = 0x10DB,
 		.device         = 0x8027,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = 0x10DB,
 		.device         = 0x8028,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = 0x10DB,
 		.device         = 0x8029,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = 0x10DB,
 		.device         = 0x800C,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	{
 		.vendor         = 0x10DB,
 		.device         = 0x800D,
 		.init		= pci_eg20t_init,
+		.setup		= pci_default_setup,
 	},
 	/*
 	 * Cronyx Omega PCI (PLX-chip based)