Skip to contentSkip to conversation

gpiolib: quiet gpiochip_add boot message noise

PATCH Applied H Hartley Sweeten 2 participants 2 messages May 11, 2012 – May 19, 2012 GPIO

lore
Share & tools
lore

H Hartley Sweeten

author
#0 lore raw

PATCH 1/1 gpiolib: quiet gpiochip_add boot message noise

The pr_info message in gpiochip_add gets displayed for every gpiochip registered. When first bringing up a system this information could be helpful but for normal use it's just a bunch of noise. Change the message to a pr_debug.

Signed-off-by H Hartley Sweeten <[email protected]>
Cc Grant Likely <[email protected]>
Cc Linus Walleij <[email protected]>

---

drivers/gpio/gpiolib.c +1 -1
index 566d012..f7972d2 100644
@@ -1093,7 +1093,7 @@ unlock:
 	if (status)
 		goto fail;
 
-	pr_info("gpiochip_add: registered GPIOs %d to %d on device: %s\n",
+	pr_debug("gpiochip_add: registered GPIOs %d to %d on device: %s\n",
 		chip->base, chip->base + chip->ngpio - 1,
 		chip->label ? : "generic");