staging: comedi: ni_daq_700: change the 'attach' printk's to dev_printk's
PATCH 22/31 staging: comedi: ni_daq_700: change the 'attach' printk's to dev_printk's
Use the dev_printk() routines to output the kernel messages in the attach routine.
The main 'attach' message had a level of KERN_ERR, I believe it should have been KERN_INFO. Also, move that message to the end of the attach so it only gets displayed if the attach is successful.
Signed-off-by H Hartley Sweeten <[email protected]>
Cc Ian Abbott <[email protected]>
Cc Frank Mori Hess <[email protected]>
Cc Greg Kroah-hartman <[email protected]>
--- drivers/staging/comedi/drivers/ni_daq_700.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-)
drivers/staging/comedi/drivers/ni_daq_700.c +6 -4
@@ -113,11 +113,8 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it)return -EIO ; iobase = link->resource[0 ]->start; -printk (KERN_ERR "comedi%d: ni_daq_700: %s, io 0x%lx\n" , dev->minor, - thisboard->name, iobase); -if (iobase ==0 ) { -printk (KERN_ERR "io base address is zero!\n" ); +dev_err (dev->class_dev,"io base address is zero!\n" );return -EINVAL ; }
@@ -142,6 +139,11 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it) s->state =0 ; s->io_bits =0x00ff ; +dev_info (dev->class_dev,"%s: %s, io 0x%lx\n" , + dev->driver->driver_name, + dev->board_name, + dev->iobase); +return 0 ; };
Signature · 1 line
1.7.11