Skip to contentSkip to conversation

x86/boot changes for v3.8

GIT PULL Ingo Molnar 1 participant 1 message Dec 11, 2012

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

Linus,

Please pull the latest x86-boot-for-linus git tree from:

git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip.git x86-boot-for-linus

HEAD: 6e87f9b7e48e165cb8e6092b9abe682e7065614a arch/x86/Kconfig: Allow turning off CONFIG_X86_MPPARSE when either ACPI or SFI is present

Two small changes: a cleanup and allow CONFIG_X86_MPPARSE to be turned off on SFI as well.

Thanks,

Ingo

------------------>
Bin Gao (1):
arch/x86/Kconfig: Allow turning off CONFIG_X86_MPPARSE when either ACPI or SFI is present

Kees Cook (1):
x86/boot/doc: Fix grammar and typo in boot.txt

 Documentation/x86/boot.txt | 4 ++--
 arch/x86/Kconfig           | 2 +-
 2 files changed, 3 insertions(+), 3 deletions(-)
Documentation/x86/boot.txt +2 -2
index 9efceff..f15cb74 100644
@@ -1013,7 +1013,7 @@ boot_params as that of 16-bit boot protocol, the boot loader should
 also fill the additional fields of the struct boot_params as that
 described in zero-page.txt.
 
-After setupping the struct boot_params, the boot loader can load the
+After setting up the struct boot_params, the boot loader can load the
 32/64-bit kernel in the same way as that of 16-bit boot protocol.
 
 In 32-bit boot protocol, the kernel is started by jumping to the
@@ -1023,7 +1023,7 @@ In 32-bit boot protocol, the kernel is started by jumping to the
 At entry, the CPU must be in 32-bit protected mode with paging
 disabled; a GDT must be loaded with the descriptors for selectors
 __BOOT_CS(0x10) and __BOOT_DS(0x18); both descriptors must be 4G flat
-segment; __BOOS_CS must have execute/read permission, and __BOOT_DS
+segment; __BOOT_CS must have execute/read permission, and __BOOT_DS
 must have read/write permission; CS must be __BOOT_CS and DS, ES, SS
 must be __BOOT_DS; interrupt must be disabled; %esi must hold the base
 address of the struct boot_params; %ebp, %edi and %ebx must be zero.
arch/x86/Kconfig +1 -1
index 46c3bff..b1494bd 100644
@@ -310,7 +310,7 @@ config X86_X2APIC
 	  If you don't know what to do here, say N.
 
 config X86_MPPARSE
-	bool "Enable MPS table" if ACPI
+	bool "Enable MPS table" if ACPI || SFI
 	default y
 	depends on X86_LOCAL_APIC
 	---help---