mpt2sas: Change in MPI2_RAID_ACTION_SYSTEM_SHUTDOWN_INITIATED notification methodology
PATCH 2/8 mpt2sas: Change in MPI2_RAID_ACTION_SYSTEM_SHUTDOWN_INITIATED notification methodology
The intent of this patch is to perform a graceful shutdown of target drives even if volume doesn't exits. Changes done in this patch
1. Removed the check for the presence of volumes before sending down MPI2_RAID_ACTION_SYSTEM_SHUTDOWN_INITIATED. Therefore, this RAID action would be sent if the card is IR Firmware.
2. The MPI2_RAID_ACTION_SYSTEM_SHUTDOWN_INITIATED is sent even when the system undergoes suspend (in addition to remove/shutdown which was already present)
Signed-off-by Sreekanth Reddy <[email protected]>
--- drivers/scsi/mpt2sas/mpt2sas_scsih.c | 5 +---- 1 files changed, 1 insertions(+), 4 deletions(-)
drivers/scsi/mpt2sas/mpt2sas_scsih.c +1 -4
@@ -7710,10 +7710,6 @@ _scsih_ir_shutdown(struct MPT2SAS_ADAPTER *ioc)if (!ioc->ir_firmware)return ; -/* are there any volumes ? */ -if (list_empty (&ioc->raid_device_list)) -return ; -mutex_lock (&ioc->scsih_cmds.mutex);if (ioc->scsih_cmds.status !=MPT2_CMD_NOT_USED ) {
@@ -8279,6 +8275,7 @@ _scsih_suspend(struct pci_dev *pdev, pm_message_t state)mpt2sas_base_stop_watchdog (ioc);scsi_block_requests (shost); +_scsih_ir_shutdown (ioc); device_state =pci_choose_state (pdev, state); printk(MPT2SAS_INFO_FMT "pdev=0x%p, slot=%s, entering " "operating state [D%d]\n", ioc->name, pdev,
Signature · 1 line
1.7.3