Pull request: u-boot-ti
Hello,
The following changes since commit 304db0b38cfb04cfdb05a740d5ef27da06ea98ea:
arm: Remove IXP425 boards pdnb3 and scpu (2013-10-17 09:28:08 +0200)
are available in the git repository at:
git://git.denx.de/u-boot-ti.git master
for you to fetch changes up to f6723794fd8f3362c4f3b5d0f36607a6a6f107b2:
TI:omap5: Add rdaddr, use consistent loadaddr values (2013-11-01 15:56:00 -0400)
----------------------------------------------------------------
Andreas Bie??mann (10):
tricorder: update flash partitioning
tricorder: use generic provided loadaddr
tricorder: add configuration for a flashcard u-boot
tricorder: add cmdline history
tricorder: add mtdparts to environment
tricorder: add tricordereeprom command
tricorder: panic() on unknown board
tricorder: add led support
tricorder: read kernel directly from NAND
tricorder: support 256MiB SDRAM on revision > D
Heiko Schocher (2):
nand, davinci: add special UBL ecc position
arm, da85x: update for the ipam390 board
Igor Grinberg (2):
cm-t35: move the eeprom code to common place
cm-t35: move the display code to common place
Javier Martinez Canillas (2):
ARM: IGEP0033: rename config file to am335x_igep0033.h
OMAP3: igep00x0: rename config file to omap3_igep00x0.hLokesh Vutla (1):
ARM: OMAP4: Convert to ti_armv7_common.h
Minal Shah (1):
dra7xx_evm: Enabled UART-boot mode and add dra7xx_evm_uart3 build
Nikita Kiryanov (3):
cm_t35: reduce default bootdelay to 3 seconds
cm_t35: turn on GPIO commands
cm_t35: update lcd predefines
SRICHARAN R (1):
ARM: OMAP5: DDR3: Change io settings
Thomas Weber (3):
tricorder: remove lcdmode from bootargs
tricorder: Make u-boot faster
tricorder: switch to alternative memtest
Tom Rini (7):
drivers/rtc/davinci.c: Reference DAVINCI_RTC_BASE more directly am33xx, davinci: Create and use <asm/davinci_rtc.h>
bootcount_davinci: Switch to scratch register #2 TI:am33xx: Add bootcount support to ti_am335x_common.h
am335x: Enable CONFIG_OMAP_WATCHDOG support TI:armv7: Change CONFIG_SYS_SPL_ARGS_ADDR to a higher address TI:omap5: Add rdaddr, use consistent loadaddr values
arch/arm/cpu/armv7/am33xx/board.c | 7 +-
arch/arm/cpu/armv7/omap-common/boot-common.c | 4 +
arch/arm/include/asm/arch-am33xx/cpu.h | 9 -
arch/arm/include/asm/arch-davinci/hardware.h | 38 ---
arch/arm/include/asm/arch-omap5/omap.h | 4 +-
arch/arm/include/asm/arch-omap5/spl.h | 1 +
arch/arm/include/asm/davinci_rtc.h | 52 ++++
board/Barix/ipam390/ipam390-ais-uart.cfg | 2 +-
board/Barix/ipam390/ipam390.c | 29 +--
board/compulab/cm_t35/Makefile | 3 -
board/compulab/cm_t35/cm_t35.c | 7 +-
board/compulab/common/Makefile | 36 +++
board/compulab/{cm_t35 => common}/eeprom.c | 51 ++--
board/compulab/{cm_t35 => common}/eeprom.h | 8 +-
.../{cm_t35/display.c => common/omap3_display.c} | 8 +-
board/corscience/tricorder/Makefile | 2 +-
board/corscience/tricorder/led.c | 80 +++++++
board/corscience/tricorder/tricorder-eeprom.c | 251 ++++++++++++++++++++
board/corscience/tricorder/tricorder-eeprom.h | 41 ++++
board/corscience/tricorder/tricorder.c | 126 +++++++++-
board/corscience/tricorder/tricorder.h | 4 +-
board/enbw/enbw_cmc/enbw_cmc.c | 1 +
board/ti/am335x/board.c | 6 +
boards.cfg | 16 +-
drivers/bootcount/Makefile | 1 +
drivers/bootcount/bootcount_davinci.c | 13 +-
drivers/mtd/nand/davinci_nand.c | 12 +
drivers/rtc/davinci.c | 8 +-
include/configs/{igep0033.h => am335x_igep0033.h} | 0
include/configs/cm_t35.h | 3 +-
include/configs/dra7xx_evm.h | 9 +-
include/configs/ipam390.h | 35 ++-
include/configs/{igep00x0.h => omap3_igep00x0.h} | 0
include/configs/omap4_common.h | 188 +++------------
include/configs/omap4_panda.h | 2 -
include/configs/omap4_sdp4430.h | 2 -
include/configs/omap5_common.h | 7 +-
include/configs/ti_am335x_common.h | 14 ++
include/configs/ti_armv7_common.h | 2 +-
include/configs/tricorder.h | 155 +++++++++---
40 files changed, 876 insertions(+), 361 deletions(-)
create mode 100644 arch/arm/include/asm/davinci_rtc.h
create mode 100644 board/compulab/common/Makefile
rename board/compulab/{cm_t35 => common}/eeprom.c (60%)
rename board/compulab/{cm_t35 => common}/eeprom.h (62%)
rename board/compulab/{cm_t35/display.c => common/omap3_display.c} (97%)
create mode 100644 board/corscience/tricorder/led.c
create mode 100644 board/corscience/tricorder/tricorder-eeprom.c
create mode 100644 board/corscience/tricorder/tricorder-eeprom.h
rename include/configs/{igep0033.h => am335x_igep0033.h} (100%)
rename include/configs/{igep00x0.h => omap3_igep00x0.h} (100%)Thanks!
Signature · 8 lines
Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: <http://lists.denx.de/pipermail/u-boot/attachments/20131104/80d6e6fa/attachment.pgp>
Hi Tom,
Quoted 119 lines · Tom Rini
Hello,
The following changes since commit
304db0b38cfb04cfdb05a740d5ef27da06ea98ea:arm: Remove IXP425 boards pdnb3 and scpu (2013-10-17 09:28:08 +0200)
are available in the git repository at:
git://git.denx.de/u-boot-ti.gitmasterfor you to fetch changes up to
f6723794fd8f3362c4f3b5d0f36607a6a6f107b2:TI:omap5: Add rdaddr, use consistent loadaddr values (2013-11-01 15:56:00 -0400)
----------------------------------------------------------------
Andreas Bie?mann (10):
tricorder: update flash partitioning
tricorder: use generic provided loadaddr
tricorder: add configuration for a flashcard u-boot
tricorder: add cmdline history
tricorder: add mtdparts to environment
tricorder: add tricordereeprom command
tricorder:panic()on unknown board
tricorder: add led support
tricorder: read kernel directly from NAND
tricorder: support 256MiB SDRAM on revision > DHeiko Schocher (2):
nand, davinci: add special UBL ecc position
arm, da85x: update for the ipam390 boardIgor Grinberg (2):
cm-t35: move the eeprom code to common place
cm-t35: move the display code to common placeJavier Martinez Canillas (2):
ARM: IGEP0033: rename config file to am335x_igep0033.h OMAP3: igep00x0: rename config file to omap3_igep00x0.hLokesh Vutla (1):
ARM: OMAP4: Convert toti_armv7_common.hMinal Shah (1):
dra7xx_evm: Enabled UART-boot mode and adddra7xx_evm_uart3buildNikita Kiryanov (3):
cm_t35: reduce default bootdelay to 3 seconds
cm_t35: turn on GPIO commands
cm_t35: update lcd predefinesSRICHARAN R (1):
ARM: OMAP5: DDR3: Change io settingsThomas Weber (3):
tricorder: remove lcdmode from bootargs
tricorder: Make u-boot faster
tricorder: switch to alternative memtestTom Rini (7):
drivers/rtc/davinci.c: ReferenceDAVINCI_RTC_BASEmore directly am33xx, davinci: Create and use <asm/davinci_rtc.h>
bootcount_davinci: Switch to scratch register #2 TI:am33xx: Add bootcount support toti_am335x_common.h
am335x: EnableCONFIG_OMAP_WATCHDOGsupport TI:armv7: ChangeCONFIG_SYS_SPL_ARGS_ADDRto a higher address TI:omap5: Add rdaddr, use consistent loadaddr valuesarch/arm/cpu/armv7/am33xx/board.c | 7 +- arch/arm/cpu/armv7/omap-common/boot-common.c | 4 + arch/arm/include/asm/arch-am33xx/cpu.h | 9 - arch/arm/include/asm/arch-davinci/hardware.h | 38 --- arch/arm/include/asm/arch-omap5/omap.h | 4 +- arch/arm/include/asm/arch-omap5/spl.h | 1 + arch/arm/include/asm/davinci_rtc.h | 52 ++++ board/Barix/ipam390/ipam390-ais-uart.cfg | 2 +- board/Barix/ipam390/ipam390.c | 29 +-- board/compulab/cm_t35/Makefile | 3 - board/compulab/cm_t35/cm_t35.c | 7 +- board/compulab/common/Makefile | 36 +++ board/compulab/{cm_t35 => common}/eeprom.c | 51 ++-- board/compulab/{cm_t35 => common}/eeprom.h | 8 +- .../{cm_t35/display.c => common/omap3_display.c} | 8 +- board/corscience/tricorder/Makefile | 2 +- board/corscience/tricorder/led.c | 80 +++++++ board/corscience/tricorder/tricorder-eeprom.c | 251 ++++++++++++++++++++ board/corscience/tricorder/tricorder-eeprom.h | 41 ++++ board/corscience/tricorder/tricorder.c | 126 +++++++++- board/corscience/tricorder/tricorder.h | 4 +- board/enbw/enbw_cmc/enbw_cmc.c | 1 + board/ti/am335x/board.c | 6 + boards.cfg | 16 +- drivers/bootcount/Makefile | 1 + drivers/bootcount/bootcount_davinci.c | 13 +- drivers/mtd/nand/davinci_nand.c | 12 + drivers/rtc/davinci.c | 8 +- include/configs/{igep0033.h => am335x_igep0033.h} | 0 include/configs/cm_t35.h | 3 +- include/configs/dra7xx_evm.h | 9 +- include/configs/ipam390.h | 35 ++- include/configs/{igep00x0.h => omap3_igep00x0.h} | 0 include/configs/omap4_common.h | 188 +++------------ include/configs/omap4_panda.h | 2 - include/configs/omap4_sdp4430.h | 2 - include/configs/omap5_common.h | 7 +- include/configs/ti_am335x_common.h | 14 ++ include/configs/ti_armv7_common.h | 2 +- include/configs/tricorder.h | 155 +++++++++--- 40 files changed, 876 insertions(+), 361 deletions(-) create mode 100644 arch/arm/include/asm/davinci_rtc.h create mode 100644 board/compulab/common/Makefile rename board/compulab/{cm_t35 => common}/eeprom.c (60%) rename board/compulab/{cm_t35 => common}/eeprom.h (62%) rename board/compulab/{cm_t35/display.c => common/omap3_display.c} (97%) create mode 100644 board/corscience/tricorder/led.c create mode 100644 board/corscience/tricorder/tricorder-eeprom.c create mode 100644 board/corscience/tricorder/tricorder-eeprom.h rename include/configs/{igep0033.h => am335x_igep0033.h} (100%) rename include/configs/{igep00x0.h => omap3_igep00x0.h} (100%)
Quoted 2 lines
Thanks!
Applied to u-boot-arm/master, thanks!
Amicalement,
Signature · 1 line
Albert.