stmicro: make local variables static
Subsystems (4)
PATCH 1/1 stmicro: make local variables static
Make variables only used in one file static. Also avoids possible namespace collisions.
Signed-off-by Stephen Hemminger <[email protected]>
drivers/net/ethernet/stmicro/stmmac/stmmac.h +0 -2
@@ -108,8 +108,6 @@ struct stmmac_priv {spinlock_t ptp_lock; }; -extern int phyaddr; -int stmmac_mdio_unregister (struct net_device *ndev);int stmmac_mdio_register (struct net_device *ndev);void stmmac_set_ethtool_ops (struct net_device *netdev);
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +1 -1
@@ -64,7 +64,7 @@ static int debug = -1;module_param (debug, int,S_IRUGO |S_IWUSR );MODULE_PARM_DESC (debug,"Message Level (-1: default, 0: no output, 16: all)" ); -int phyaddr =-1 ; +static int phyaddr =-1 ;module_param (phyaddr, int,S_IRUGO );MODULE_PARM_DESC (phyaddr,"Physical device address" );
drivers/net/ethernet/stmicro/stmmac/stmmac_pci.c +3 -3
@@ -26,9 +26,9 @@#include <linux/pci.h> #include "stmmac.h" -struct plat_stmmacenet_data plat_dat; -struct stmmac_mdio_bus_data mdio_data; -struct stmmac_dma_cfg dma_cfg; +static struct plat_stmmacenet_data plat_dat; +static struct stmmac_mdio_bus_data mdio_data; +static struct stmmac_dma_cfg dma_cfg;static void stmmac_default_data (void ) {
From: Stephen Hemminger <[email protected]>
Date: Mon, 30 Dec 2013 10:38:57 -0800
Quoted 4 lines
Make variables only used in one file static. Also avoids possible namespace collisions.
Signed-off-by Stephen Hemminger <[email protected]>
Applied.