Skip to contentSkip to conversation

ARM: shmobile: Remove KZM9D board code

PATCH New Magnus Damm 2 participants 2 messages Feb 17, 2014

Subsystems (4)
lore
Share & tools
lore

Magnus Damm

author maintainer
#0 lore raw

PATCH v2 1/1 ARM: shmobile: Remove KZM9D board code

From: Magnus Damm <[email protected]>

Get rid of KZM9D board code written in C. This version of the C board code was used in the case of multiplatform, but these days DT can be used instead, so because of that simply get rid of the C code to simplify and save space.

---

Written against renesas-devel-v3.14-rc3-20140217

Changes since V1:
- Got rid of code that modified the file emev2.h

 arch/arm/mach-shmobile/Kconfig                 |    6 ---
 arch/arm/mach-shmobile/Makefile                |    1 
 arch/arm/mach-shmobile/board-kzm9d-reference.c |   47 ------------------------
 3 files changed, 54 deletions(-)
arch/arm/mach-shmobile/Kconfig +0 -6
@@ -48,12 +48,6 @@ config MACH_KOELSCH
 	depends on ARCH_R8A7791
 	select MICREL_PHY if SH_ETH
 
-config MACH_KZM9D
-	bool "KZM9D board"
-	depends on ARCH_EMEV2
-	select REGULATOR_FIXED_VOLTAGE if REGULATOR
-	select SMSC_PHY if SMSC911X
-
 config MACH_LAGER
 	bool "Lager board"
 	depends on ARCH_R8A7790
arch/arm/mach-shmobile/Makefile +0 -1
@@ -58,7 +58,6 @@ obj-$(CONFIG_ARCH_R8A7790)	+= pm-r8a7790
 ifdef CONFIG_ARCH_SHMOBILE_MULTI
 obj-$(CONFIG_MACH_GENMAI)	+= board-genmai-reference.o
 obj-$(CONFIG_MACH_KOELSCH)	+= board-koelsch-reference.o
-obj-$(CONFIG_MACH_KZM9D)	+= board-kzm9d-reference.o
 obj-$(CONFIG_MACH_LAGER)	+= board-lager-reference.o
 else
 obj-$(CONFIG_MACH_APE6EVM)	+= board-ape6evm.o
arch/arm/mach-shmobile/board-kzm9d-reference.c deleted +0 -47

47 lines not on this page · raw message

#1 lore raw

PATCH v2 1/1 ARM: shmobile: Remove KZM9D board code

Quoted 8 lines · Magnus Damm

From: Magnus Damm <[email protected]>

Get rid of KZM9D board code written in C. This version of the C board code was used in the case of multiplatform, but these days DT can be used instead, so because of that simply get rid of the C code to simplify and save space.

Thanks Magnus, I have queued this up.