ARM: dts: omap3-overo: Fix UART wake-up events

Compared to legacy booting, we don't have wake-up events enabled for device tree based booting. This means that if deeper idle states are enabled, the device won't wake up to UART events and seems like it has hung.

Let's fix that by adding the wake-up interrupt. Note that we don't need to set the PIN_OFF_WAKEUPENABLE any longer, that's handled by the wake-up interrupt when the serial driver does request_irq on it.

Tested with the following on omap3-overo-summit that has the ES2.1 omap:

#!/bin/bash

uarts=$(find /sys/class/tty/ttyO*/device/power/ -type d) for uart in $uarts; do
echo 3000 > $uart/autosuspend_delay_ms
done

uarts=$(find /sys/class/tty/ttyO*/power/ -type d)
for uart in $uarts; do
echo enabled > $uart/wakeup
echo auto > $uart/control
done

echo 1 > /sys/kernel/debug/pm_debug/enable_off_mode

# grep -i uart /proc/interrupts
 90:       1085      INTC  74  OMAP UART2
338:          5   pinctrl 366  OMAP UART2

# grep ^core_pwrdm /sys/kernel/debug/pm_debug/count
core_pwrdm (ON),OFF:1654,RET:131,INA:39,ON:1825...

@@ -36,8 +36,8 @@
 
 	uart3_pins: pinmux_uart3_pins {
 		pinctrl-single,pins = <
-			OMAP3_CORE1_IOPAD(0x219e, PIN_INPUT | PIN_OFF_WAKEUPENABLE | MUX_MODE0)	/* uart3_rx_irrx.uart3_rx_irrx */
-			OMAP3_CORE1_IOPAD(0x21a0, PIN_OUTPUT | MUX_MODE0)		/* uart3_tx_irtx.uart3_tx_irtx */
+			OMAP3_CORE1_IOPAD(0x219e, PIN_INPUT | MUX_MODE0)	/* uart3_rx_irrx.uart3_rx_irrx */
+			OMAP3_CORE1_IOPAD(0x21a0, PIN_OUTPUT | MUX_MODE0)	/* uart3_tx_irtx.uart3_tx_irtx */
 		>;
 	};
 };

@@ -88,6 +88,7 @@
 };
 
 &uart3 {
+	interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart3_pins>;
 };