Skip to contentSkip to conversation

should pinmux setting be put into board specific dts or SoC specific dtsi?

Query Jisheng Zhang 2 participants 3 messages Jan 21, 2015

lore
Share & tools
lore
#0 lore raw

Hi,

IIUC, the pinmux setting is board specific. So my question is where to put the pinmux settings? Board specific dts or SoC specific dtsi? Could anyone kindly help me?

Thanks in advance,
Jisheng

#1 lore raw
Quoted 3 lines · Jisheng Zhang

IIUC, the pinmux setting is board specific. So my question is where to put the pinmux settings? Board specific dts or SoC specific dtsi? Could anyone kindly help me?

Jisheng,

it depends on the pinmux setting whether it should go in to SoC dtsi or board dts. For example, the pinmux setting for internal devices like UART - where there is only one or two possible settings - should go into SoC dtsi. Also, if there is only one possible setting or one default/common setting, the SoC dtsi node should already have the corresponding pinctrl properties. If a specific board uses another setting, it can always overwrite the default property with the one used at board level.

A good example for board specific pinmux settings clearly is GPIO, e.g. you have a regulator for USB power that is controlled by GPIO then you'll have the regulator node on board level and also the corresponding pinmux settings for that very GPIO pin.

If you give a specific example of what pinmux setting bothers you, we can try to find a good place for it.

Sebastian

#2 lore raw

Dear Sebastian,

Quoted 16 lines · On Wed, 21 Jan 2015 02:38:27 -0800 Sebastian Hesselbarth…
Quoted 3 lines · Jisheng Zhang

IIUC, the pinmux setting is board specific. So my question is where to put the pinmux settings? Board specific dts or SoC specific dtsi? Could anyone kindly help me?

Jisheng,

it depends on the pinmux setting whether it should go in to SoC dtsi or board dts. For example, the pinmux setting for internal devices like UART - where there is only one or two possible settings - should go into SoC dtsi. Also, if there is only one possible setting or one default/common setting, the SoC dtsi node should already have the corresponding pinctrl properties. If a specific board uses another setting, it can always overwrite the default property with the one used at board level.

Quoted 4 lines

A good example for board specific pinmux settings clearly is GPIO, e.g. you have a regulator for USB power that is controlled by GPIO then you'll have the regulator node on board level and also the corresponding pinmux settings for that very GPIO pin.

Thanks very much for the detailed explanation. The regulator is the case I care ;)

Quoted 5 lines

If you give a specific example of what pinmux setting bothers you, we can try to find a good place for it.

Sebastian