Skip to contentSkip to conversation

How to increase maximum user cpu usage allowed on a multi core system?

DISCUSSION poma 2 participants 2 messages Mar 17, 2015 1 message not in the archive

lore
Share & tools
lore

poma

author
#1 lore raw
In reply to a message not in the archive
Quoted 23 lines · stan

I'm running Fedora 21 with a custom compiled kernel, 3.19.0-1.20150211.fc21.x86_64.

I have a multi core system with 6 cores. All are recognized by the kernel.

But, when I run a compile job with -j6, in order to allow all six cores to be used, it limits the total amount of usage to 100% of a *single* core. So, it might use all six cores, but the sum of the percentages on those six cores is always around 100% of one core. This is from htop output.

On large compilations, like the kernel or firefox, even using 4 cores could drastically reduce compile time.

I've looked at /etc/security/limits.conf, but it doesn't seem to have a setting for this. I've also looked at the /proc system to see if there is a kernel variable, though that seems unlikely, with no luck. Online searching found ways to limit the amount that a single job can get, but not how to set this for a user. There must be a configuration variable somewhere that is limiting the amount of total cpu a user can use. But I can't find it.

Quoted 2 lines

Can anyone help?

Borislav, can you help explain the man why this is happening with his Piledriver.
http://www.cpu-world.com/CPUs/Bulldozer/AMD-FX-Series%20FX-6300.html

poma

#2 lore raw
Quoted 4 lines · poma
Quoted 3 lines · stan

I'm running Fedora 21 with a custom compiled kernel, 3.19.0-1.20150211.fc21.x86_64.

Quoted 8 lines
Quoted 8 lines

I have a multi core system with 6 cores. All are recognized by the kernel.

But, when I run a compile job with -j6, in order to allow all six cores to be used, it limits the total amount of usage to 100% of a *single* core. So, it might use all six cores, but the sum of the percentages on those six cores is always around 100% of one core. This is from htop output.

Let me try to understand this correctly?

You're building the kernel with

make -j6

but in htop you're seeing a single core at 100% and the rest are idle? Yes, no?

What exact steps are you doing to build the kernel? Type them here please so that I can do them exactly on my system too.

Also, please send a full dmesg from your system, private message is fine too.

Thanks.

Signature · 5 lines
Regards/Gruss,
    Boris.

ECO tip #101: Trim your mails when you reply.
--