ixgbe: cannot enable LRO
Subsystems (2)
Hello everyone,
does anybody have a problem with LRO on ixge (on latest 4.6-rc5)? I cannot find a way to enable it.
On stable RHEL7.2 kernel everything works fine.
I opened a bug report [0].
[0] https://bugzilla.kernel.org/show_bug.cgi?id=117291
Thanks!
Ota
Quoted 7 lines · Otto Sabart
Hello everyone,
does anybody have a problem with LRO on ixge (on latest 4.6-rc5)? I cannot find a way to enable it.On stable RHEL7.2 kernel everything works fine.
Quoted 8 lines
I opened a bug report [0].
[0] https://bugzilla.kernel.org/show_bug.cgi?id=117291
Thanks!
Ota
So I am able to turn on LRO without any issues.
Do you know if you have done anything that might disable LRO such as modified the rx-usecs to a value less than 10 or enabled routing or bridging on the device? Also I think a stacked device might be able to block you from enabling LRO unless all the devices stacked on the interface can support it.
- Alex
Quoted 8 lines · Otto Sabart
Quoted 7 lines
Hello everyone,
does anybody have a problem with LRO on ixge (on latest 4.6-rc5)? I cannot find a way to enable it.On stable RHEL7.2 kernel everything works fine.
Quoted 9 lines
Quoted 8 lines
I opened a bug report [0].
[0] https://bugzilla.kernel.org/show_bug.cgi?id=117291
Thanks!
Ota
Hello Alex,
Quoted 1 line
So I am able to turn on LRO without any issues.
Yes, I badly desciribed the problem. The LRO was not possible to turn on immediately _after the boot_ (I was enabling it in /etc/rc.local).
When I reloaded the ixgbe driver, the LRO was possible to turn on without problem.
I found out that the problem was caused by network manager. When I disabled NM, the LRO started to work.
Quoted 6 lines
Do you know if you have done anything that might disable LRO such as modified the rx-usecs to a value less than 10 or enabled routing or bridging on the device? Also I think a stacked device might be able to block you from enabling LRO unless all the devices stacked on the interface can support it.
I did not modify rx-usecs (at least not intentionally). Its value is always (with disabled or enabled LRO) equal to 1 (with disabled NM).
$ ethtool -c ixgbe | grep rx-usecs rx-usecs: 1 rx-usecs-irq: 0 rx-usecs-low: 0 rx-usecs-high: 0
There is no linux bridge or routing enabled on this device. There is only a VLAN configured. Does it matter?
$ ip l show ixgbe
9: ixgbe: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode DEFAULT qlen 1000
link/ether 00:1b:21:90:c3:86 brd ff:ff:ff:ff:ff:ff$ ip l show ixgbe.40
19: ixgbe.40@ixgbe: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT qlen 1000
link/ether 00:1b:21:90:c3:86 brd ff:ff:ff:ff:ff:ffI updated the bugzilla [0] and I think we can close this as a NOTABUG.
Thanks!
Ota