Skip to contentSkip to conversation

sgtl5000: check VDDD-supply instead of revision

RFC In review Clemens Gruber 2 participants 2 messages May 31, 2016

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

RFC 1/1 sgtl5000: check VDDD-supply instead of revision

Hi,

I am using a SGTL5000 rev 0x11 with external VDDD, as recommended by NXP documentation and errata sheet:
http://cache.nxp.com/files/analog/doc/errata/SGTL5000ER.pdf
The linux sgtl5000 codec driver contains a comment, warning that external VDDD can't be used on revisions >= 0x11, which is probably a leftover from the first implementation. This is very confusing because it contradicts the NXP documentation.
Also, on every boot, the user gets a warning that the SGTL5000 is using the internal LDO (even though external VDDD is present).

Maybe instead of checking the revision, we should only check if the VDDD-supply regulator exists and only if it does not exist, call sgtl5000_replace_vddd_with_ldo?

I'd like to hear your comments if this approach is valid or if I missed something in my assumptions.

In my DT, the VDDD-supply regulator is just a dummy / regulator-fixed with regulator-always-on; set, because the 1.8V external VDDD supply on my board is always powered on.
I could not test if it works with regulator-fixed with gpio nodes, which actually switch the supply line on or off.

If everything is OK, I'd send a formal patch to the mailing list. See below for the current state of my patch.

Tested on an i.MX6Q board with SGTL5000 rev 0x11 and external VDDD.

Thanks,
Clemens

---
 sound/soc/codecs/sgtl5000.c | 19 ++++++++-----------
 1 file changed, 8 insertions(+), 11 deletions(-)
sound/soc/codecs/sgtl5000.c +8 -11
index 08b4046..fbad4fb 100644
@@ -1286,17 +1286,14 @@ static int sgtl5000_enable_regulators(struct snd_soc_codec *codec)
 	for (i = 0; i < ARRAY_SIZE(sgtl5000->supplies); i++)
 		sgtl5000->supplies[i].supply = supply_names[i];
 
-	/* External VDDD only works before revision 0x11 */
-	if (sgtl5000->revision < 0x11) {
-		vddd = regulator_get_optional(codec->dev, "VDDD");
-		if (IS_ERR(vddd)) {
-			/* See if it's just not registered yet */
-			if (PTR_ERR(vddd) == -EPROBE_DEFER)
-				return -EPROBE_DEFER;
-		} else {
-			external_vddd = 1;
-			regulator_put(vddd);
-		}
+	vddd = regulator_get_optional(codec->dev, "VDDD");
+	if (IS_ERR(vddd)) {
+		/* See if it's just not registered yet */
+		if (PTR_ERR(vddd) == -EPROBE_DEFER)
+			return -EPROBE_DEFER;
+	} else {
+		external_vddd = 1;
+		regulator_put(vddd);
 	}
 
 	if (!external_vddd) {
Signature · 1 line
2.8.3
#1 lore raw

[Sorry for the top-post]

I think this makes sense. Please submit a formal patch, thanks.

________________________________________
From: Clemens Gruber <[email protected]>
Sent: Tuesday, May 31, 2016 1:58:03 PM
To: [email protected]
Cc: Mark Brown; Fabio Estevam
Subject: [RFC] sgtl5000: check VDDD-supply instead of revision

Hi,

I am using a SGTL5000 rev 0x11 with external VDDD, as recommended by NXP documentation and errata sheet:
http://cache.nxp.com/files/analog/doc/errata/SGTL5000ER.pdf
The linux sgtl5000 codec driver contains a comment, warning that external VDDD can't be used on revisions >= 0x11, which is probably a leftover from the first implementation. This is very confusing because it contradicts the NXP documentation.
Also, on every boot, the user gets a warning that the SGTL5000 is using the internal LDO (even though external VDDD is present).

Maybe instead of checking the revision, we should only check if the VDDD-supply regulator exists and only if it does not exist, call sgtl5000_replace_vddd_with_ldo?

I'd like to hear your comments if this approach is valid or if I missed something in my assumptions.

In my DT, the VDDD-supply regulator is just a dummy / regulator-fixed with regulator-always-on; set, because the 1.8V external VDDD supply on my board is always powered on.
I could not test if it works with regulator-fixed with gpio nodes, which actually switch the supply line on or off.

If everything is OK, I'd send a formal patch to the mailing list. See below for the current state of my patch.

Tested on an i.MX6Q board with SGTL5000 rev 0x11 and external VDDD.

Thanks,
Clemens

---
 sound/soc/codecs/sgtl5000.c | 19 ++++++++-----------
 1 file changed, 8 insertions(+), 11 deletions(-)
sound/soc/codecs/sgtl5000.c +8 -11
index 08b4046..fbad4fb 100644
@@ -1286,17 +1286,14 @@ static int sgtl5000_enable_regulators(struct snd_soc_codec *codec)
        for (i = 0; i < ARRAY_SIZE(sgtl5000->supplies); i++)
                sgtl5000->supplies[i].supply = supply_names[i];
 
-       /* External VDDD only works before revision 0x11 */
-       if (sgtl5000->revision < 0x11) {
-               vddd = regulator_get_optional(codec->dev, "VDDD");
-               if (IS_ERR(vddd)) {
-                       /* See if it's just not registered yet */
-                       if (PTR_ERR(vddd) == -EPROBE_DEFER)
-                               return -EPROBE_DEFER;
-               } else {
-                       external_vddd = 1;
-                       regulator_put(vddd);
-               }
+       vddd = regulator_get_optional(codec->dev, "VDDD");
+       if (IS_ERR(vddd)) {
+               /* See if it's just not registered yet */
+               if (PTR_ERR(vddd) == -EPROBE_DEFER)
+                       return -EPROBE_DEFER;
+       } else {
+               external_vddd = 1;
+               regulator_put(vddd);
        }
 
        if (!external_vddd) {

--
2.8.3