i2c: mvtwsi: Fix order of address bytes (high to low)
PATCH 1/1 i2c: mvtwsi: Fix order of address bytes (high to low)
Patch f8a10ed1 [i2c: mvtwsi: Make address length variable] accidentally inverted the sequence of address bytes sent to the I2C device. This patch corrects this by sending the highest byte first and the lowest byte last again.
Tested on theadorable Armada-XP board.
Signed-off-by Stefan Roese <[email protected]>
Cc Mario Six <[email protected]>
Cc Heiko Schocher <[email protected]>
--- drivers/i2c/mvtwsi.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/i2c/mvtwsi.c +2 -2
@@ -595,7 +595,7 @@ static int __twsi_i2c_read(struct mvtwsi_registers *twsi, uchar chip, status =i2c_begin (twsi, expected_start, (chip <<1 ), tick);/* Send address bytes */ while ((status ==0 ) && alen--) - status =twsi_send (twsi, *(addr++), + status =twsi_send (twsi, addr[alen],MVTWSI_STATUS_DATA_W_ACK , tick);/* Send repeated STARTs after the initial START */ expected_start =MVTWSI_STATUS_REPEATED_START ;
@@ -642,7 +642,7 @@ static int __twsi_i2c_write(struct mvtwsi_registers *twsi, uchar chip, status =i2c_begin (twsi,MVTWSI_STATUS_START , (chip <<1 ), tick);/* Send address bytes */ while ((status ==0 ) && (alen-- >0 )) - status =twsi_send (twsi, *(addr++),MVTWSI_STATUS_DATA_W_ACK , + status =twsi_send (twsi, addr[alen],MVTWSI_STATUS_DATA_W_ACK , tick);/* Send data bytes */ while ((status ==0 ) && (length-- >0 ))
Signature · 1 line
2.9.3