ARM: dts: sun8i-h3: Add dts for the Beelink X2 STB
Subsystems (3)
PATCH v2 1/1 ARM: dts: sun8i-h3: Add dts for the Beelink X2 STB
From: Marcus Cooper <[email protected]>
The Beelink X2 is an STB based on the Allwinner H3 SoC with a uSD slot, 2 USB ports( 1 * USB-2 Host, 1 USB OTG), a 10/100M ethernet port using the SoC's integrated PHY, Wifi via an sdio wifi chip, HDMI, an IR receiver, a dual colour LED and an optical S/PDIF connector.
Signed-off-by Marcus Cooper <[email protected]>
--- arch/arm/boot/dts/Makefile | 1 + arch/arm/boot/dts/sun8i-h3-beelink-x2.dts | 136 ++++++++++++++++++++++++++++++ 2 files changed, 137 insertions(+) create mode 100644 arch/arm/boot/dts/sun8i-h3-beelink-x2.dts
arch/arm/boot/dts/Makefile +1 -0
@@ -860,6 +860,7 @@ dtb-$(CONFIG_MACH_SUN8I) += \ sun8i-a83t-cubietruck-plus.dtb \ sun8i-h2-plus-orangepi-zero.dtb \ sun8i-h3-bananapi-m2-plus.dtb \ + sun8i-h3-beelink-x2.dtb \ sun8i-h3-nanopi-m1.dtb \ sun8i-h3-nanopi-neo.dtb \ sun8i-h3-orangepi-2.dtb \
arch/arm/boot/dts/sun8i-h3-beelink-x2.dts new file +136 -0
136 lines not on this page · raw message
Signature · 1 line
2.11.0