regulator: gpio-regulator: doc: correct default type
Subsystems (2)
PATCH 1/1 regulator: gpio-regulator: doc: correct default type
The driver defaults to voltage, not current, type so correct this in the device tree binding documentation.
Signed-off-by Hans Holmberg <[email protected]>
---
See drivers/regulator/gpio-regulator.c:231
..and the example in the binding doc is voltage regulator without regulator-type specified.
Documentation/devicetree/bindings/regulator/gpio-regulator.txt | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
Documentation/devicetree/bindings/regulator/gpio-regulator.txt +1 -1
@@ -13,7 +13,7 @@ Optional properties: - startup-delay-us : Startup time in microseconds. - enable-active-high : Polarity of GPIO is active high (default is low). - regulator-type : Specifies what is being regulated, must be either - "voltage" or "current", defaults to current. + "voltage" or "current", defaults to voltage. Any property defined as part of the core regulator binding defined in regulator.txt can also be used.
Signature · 1 line
1.9.1