Using X550 on unidirectional links
Hi,
I'm trying to get an ixgbe card (X550EM_X_SFP as integrated in the Xeon D-1500 on a Supermicro X10SDV-2C-TP4F board) to transmit via a 1000BASE-SX SFP even when not receiving a signal. While setting the FLU bit in MACC causes the link detection to signal a link up and the transmit counters go up when sending packets, nothing seems to go out on the wire.
I guess some part of the PHY or the controller's firmware is dropping the packets because no carrier is being sensed and/or autonegotiation cannot proceed. Is there a way to override this behavior? The driver is poking numerous PHY registers, but I've not been able to find a list of those.
I've also thought about using the PHY loopbacks mentioned in the datasheet to achieve this, but there's no description on how to actually configure those.
Can somebody point me into the right direction on this?
Thanks,
Florian