Skip to contentSkip to conversation

remoteproc: make REMOTEPROC a menuconfig to ease disabling it all

PATCH New Vincent Legoll 1 participant 1 message Dec 9, 2017 Remote processor (remoteproc)

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 remoteproc: make REMOTEPROC a menuconfig to ease disabling it all

No need to get into the submenu to disable all related config entries.

This makes it easier to disable all REMOTEPROC config options without entering the submenu. It will also enable one to see that en/dis-abled state from the outside menu.

This is only intended to change menuconfig UI, not change the config dependencies.

---
 drivers/remoteproc/Kconfig | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)
drivers/remoteproc/Kconfig +5 -5
index b609e1d3654b..29341c7d836d 100644
@@ -1,4 +1,7 @@
-menu "Remoteproc drivers"
+menuconfig REMOTEPROC_MENU
+	bool "Remoteproc drivers"
+
+if REMOTEPROC_MENU
 
 config REMOTEPROC
 	tristate "Support for Remote Processor subsystem"
@@ -10,8 +13,6 @@ config REMOTEPROC
 	  Support for remote processors (such as DSP coprocessors). These
 	  are mainly used on embedded systems.
 
-if REMOTEPROC
-
 config IMX_REMOTEPROC
 	tristate "IMX6/7 remoteproc support"
 	depends on SOC_IMX6SX || SOC_IMX7D
@@ -140,6 +141,5 @@ config ST_REMOTEPROC
 config ST_SLIM_REMOTEPROC
 	tristate
 
-endif # REMOTEPROC
+endif # REMOTEPROC_MENU
 
-endmenu
Signature · 1 line
2.14.1