Skip to contentSkip to conversation

tty: New RISC-V SBI console driver

PATCH New Palmer Dabbelt 1 participant 1 message Mar 8, 2018

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 tty: New RISC-V SBI console driver

The RISC-V ISA defines a simple console that is availiable via SBI calls on all systems. The SBI console is designed to be availiable at all times, so while it's most natural to use this as an early printk target it's also possible to use this as the system console when there isn't a better one availiable.

This patch adds support for the RISC-V SBI console via the HVC infastructure. It's entirely independent from our early printk support, which results in early boot messages appearing twice over the SBI console. As far as I can tell that's the fault of our early printk support (we should support earlycon) as opposed to this driver.

There is one checkpatch.pl warning here: to check the MAINTAINERS file. They're all matched by the "K: riscv" line.

---
 drivers/tty/hvc/Kconfig         | 10 +++++++
 drivers/tty/hvc/Makefile        |  1 +
 drivers/tty/hvc/hvc_riscv_sbi.c | 60 +++++++++++++++++++++++++++++++++++++++++
 3 files changed, 71 insertions(+)
 create mode 100644 drivers/tty/hvc/hvc_riscv_sbi.c
drivers/tty/hvc/Kconfig +10 -0
index fec457edad14..e7cc617d6e45 100644
@@ -97,6 +97,16 @@ config HVC_BFIN_JTAG
 	 the HVC driver.  If you don't have JTAG, then you probably don't
 	 want this option.
 
+config HVC_RISCV_SBI
+	bool "RISC-V SBI console support"
+	depends on RISCV
+	select HVC_DRIVER
+	help
+	  This enables support for console output via RISC-V SBI calls, which
+	  is normally used only during boot to output printk.
+
+	  If you don't know what do to here, say Y.
+
 config HVCS
 	tristate "IBM Hypervisor Virtual Console Server support"
 	depends on PPC_PSERIES && HVC_CONSOLE
drivers/tty/hvc/Makefile +1 -0
index 0b02ec7f1dfd..83079ae000ae 100644
@@ -11,4 +11,5 @@ obj-$(CONFIG_HVC_XEN)		+= hvc_xen.o
 obj-$(CONFIG_HVC_IUCV)		+= hvc_iucv.o
 obj-$(CONFIG_HVC_UDBG)		+= hvc_udbg.o
 obj-$(CONFIG_HVC_BFIN_JTAG)	+= hvc_bfin_jtag.o
+obj-$(CONFIG_HVC_RISCV_SBI)	+= hvc_riscv_sbi.o
 obj-$(CONFIG_HVCS)		+= hvcs.o
drivers/tty/hvc/hvc_riscv_sbi.c new file +60 -0

60 lines not on this page · raw message

Signature · 1 line
2.16.1