Connection between two clients
Hello,
I have a problem establishing a direct connection between two clients, my setup is the following:
Client1 <--> Server <--> Client2
i.e. I have a publicly reachable server, and two clients that are connected to the server. My configurations are:
Server.conf
[Interface]
PrivateKey = ServerPrivateKey
ListenPort = 51820
Address = 192.168.12.1/24
[Peer]
PublicKey = Client1PublicKey
AllowedIPs = 192.168.12.3/32
[Peer]
PublicKey = Client1PublicKey
AllowedIPs = 192.168.12.2/32
Client1.conf
[Interface]
PrivateKey = Client1PrivateKey
ListenPort = 21003
Address = 192.168.12.3/24
[Peer]
PublicKey = ServerPublicKey
Endpoint = myserver.com:51820
AllowedIPs = 192.168.12.1/24
PersistentKeepalive = 25
Client2.conf
[Interface]
PrivateKey = Client2PrivateKey
ListenPort = 21002
Address = 192.168.12.2/24
[Peer]
PublicKey = ServerPublicKey
Endpoint = myserver.com:51820
AllowedIPs = 192.168.12.1/24
PersistentKeepalive = 25
I am able to ping between client1 to server and client2 to server. However trying to ping client2 from client1 directly fails... Looking at the server with tcpdump I can see, that there is an incoming ping from 192.168.12.3 > 192.168.12.2, however there is nothing reaching at 192.168.12.2. The ping is not forwarded to 192.168.12.2. Do I need to setup iptables rules? What's the easiest way to get a direct connection between two clients?
Cheers
Andreas
Probanly a routing problem, check ip route show on (one) client and server.
Also you might need to enable ip forwarding on server (usually enabled on firewalls and routers). No iptables are not necessary if everything is one subnet.
Cheers,
Kalin.
Here is some documentation on how some of this can be done:
https://unix.stackexchange.com/questions/14056/what-is-kernel-ip-forwarding/14058#14058
Quoted 14 lines · Kalin KOZHUHAROV
Probanly a routing problem, check
ip route showon (one) client and server.Also you might need to enable ip forwarding on server (usually enabled on firewalls and routers). No iptables are not necessary if everything is one subnet.
Cheers,
Kalin._______________________________________________
WireGuard mailing list
[email protected]
https://lists.zx2c4.com/mailman/listinfo/wireguard
Quoted 9 lines · On Thu, 16 Aug 2018 21:40:20 +0200 Kalin KOZHUHAROV <[email protected]> wrote:
Probanly a routing problem, check
ip route showon (one) client and server.Also you might need to enable ip forwarding on server (usually enabled on firewalls and routers). No iptables are not necessary if everything is one subnet.
Cheers,
Kalin.
Yes, the ip forwarding was the trick I was missing.
Maybe it is worth adding a note in the documentation/quick start guide that this is needed for client-to-client communication through a server.
Thank you
Andreas