serial: 8250_dw: Fix runtime PM handling
Quoted 6 lines · Phil Edworthy
When using kgdb, you get an abort when accessing the UART registers. This is because the driver has already entered runtime PM and so turned off the bus clock needed to access the registers.
To fix this, set the capability indicating Runtime PM is active while idle.
With this patch applied, I get the already reported traceback [1]. Obviously neither the promised revert [2] nor the presumed fix [3] made it into the mainline Kernel.
Greg, can you please revert this patch ? If people don't care enough to fix the problem, we should at least not have to suffer the consequences.
Thanks,
Guenter
Quoted 23 lines
Signed-off-by Phil Edworthy <[email protected]>Signed-off-by Greg Kroah-Hartman <[email protected]>--- drivers/tty/serial/8250/8250_dw.c | 4 ++++ 1 file changed, 4 insertions(+)drivers/tty/serial/8250/8250_dw.c +4
-0@@ -576,6 +576,10 @@ static int dw8250_probe(struct platform_device *pdev)if (!data->skip_autocfg)dw8250_setup_port (p); +#ifdef CONFIG_PM + uart.capabilities |=UART_CAP_RPM ; +#endif +/* If we have a valid fifosize, try hooking up DMA */ if (p->fifosize) { data->dma.rxconf.src_maxburst = p->fifosize /4 ;Signature · 1 line
2.7.4
---
[1] https://www.spinics.net/lists/linux-serial/msg30379.html
[2] https://www.spinics.net/lists/linux-serial/msg30380.html
[3] https://www.spinics.net/lists/linux-serial/msg30757.html
Quoted 8 lines · Guenter Roeck
Quoted 6 lines · Phil Edworthy
When using kgdb, you get an abort when accessing the UART registers. This is because the driver has already entered runtime PM and so turned off the bus clock needed to access the registers.
To fix this, set the capability indicating Runtime PM is active while idle.
Quoted 6 lines
With this patch applied, I get the already reported traceback [1]. Obviously neither the promised revert [2] nor the presumed fix [3] made it into the mainline Kernel.
Greg, can you please revert this patch ? If people don't care enough to fix the problem, we should at least not have to suffer the consequences.
Yes please revert until things are fixed.
FYI, what Andy and I discussed earlier is that we can disable runtime PM for serial layer by taking a PM runtime use count on the serial driver if there is an active console but we need a way to attach/detach kernel serial consoel via /sys to prevent regressions with PM.
So how do we attach/detach kernel serial console? We don't seem to have a way to attach/detach a kernel console to a UART via /sys do we? Or am I again 10 years behind or something?
We have /sys/class/vtconsole to bind and unbind a frame buffer console though.
Andy, do you have your updated patches available somewhere?
Regards,
Tony