arm: mvebu: armada-xp-theadorable.dts: Add "spi-flash" compatible property
PATCH 1/2 arm: mvebu: armada-xp-theadorable.dts: Add "spi-flash" compatible property
Add the "spi-flash" compatible string so that the generic sf_probe driver can probe the SPI flash on the theadorable Armada-XP board.
Signed-off-by Stefan Roese <[email protected]>
--- arch/arm/dts/armada-xp-theadorable.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/dts/armada-xp-theadorable.dts +1 -1
@@ -134,7 +134,7 @@ u-boot,dm-pre-reloc; #address-cells = <1>; #size-cells = <1>; - compatible = "n25q128a13", "jedec,spi-nor"; + compatible = "n25q128a13", "jedec,spi-nor", "spi-flash"; reg = <0>; /* Chip select 0 */ spi-max-frequency = <27777777>; };
Signature · 1 line
2.19.1
PATCH 2/2 arm: mvebu: armada-xp-theadorable.dts: Change CS# for 2nd FPGA
The new board version has the 2nd FPGA connected via CS# 0 instead of 2 on SPI bus 1. Change this setup in the DT accordingly. Please note that this change does still work on the old board version because the CS signal is not used on this board.
Signed-off-by Stefan Roese <[email protected]>
--- arch/arm/dts/armada-xp-theadorable.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
arch/arm/dts/armada-xp-theadorable.dts +2 -2
@@ -151,11 +151,11 @@ spi1: spi at 10680 { status = "okay"; - fpga at 2 { + fpga at 0 { #address-cells = <1>; #size-cells = <1>; compatible = "spi-generic-device"; - reg = <2>; /* Chip select 2 */ + reg = <0>; /* Chip select 0 */ spi-max-frequency = <27777777>; }; };
Signature · 1 line
2.19.1