s390x: Switch to z/Arch if needed
A message that is not in the archive (sent off-list or not yet received): [email protected]
David Hildenbrand
Reviewed-byQuoted 26 lines · Janosch Frank
LPAR and z/VM start in esam mode depending on the hardware, so we need to switch to z/Arch and set 64 bit addressing.
Under Qemu/KVM we already start out with both when being run with the Qemu --kernel argument or we lack 64 bit when booting from disk because of the initial psw specifying 31 bit for z/VM and lpar compatibility.
Signed-off-by Janosch Frank <[email protected]>--- s390x/cstart64.S | 8 ++++++++ 1 file changed, 8 insertions(+)s390x/cstart64.S +1
-0@@ -20,9 +20,17 @@ * * For KVM and TCG kernel boot we are in 64 bit z/Arch mode. * When booting from disk the initial short psw is in 31 bit mode. + * When running under LPAR or z/VM, we might start in 31 bit and esam mode. */ .globl start start:
s390x/cstart64.S line 36
Quoted 10 lines
s390x/cstart64.S +7
-0+ /* Switch to z/Architecture mode and 64-bit */ + slr %r0, %r0 # Set cpuid to zero + lhi %r1, 2 # mode 2 = esame + sigp %r1, %r0, 0x12 # sigp set arch + bras %r13,0f # Jump over zero area + .fill 16,4,0x0 # Zero area for lmh +0: lmh %r0,%r15,0(%r13) # Clear high-order half of gprs sam64 # Set addressing mode to 64 bit /* setup stack */ larl %r15, stackptr
Reviewed-by David Hildenbrand <[email protected]>
Signature · 3 lines
Thanks, David / dhildenb