Skip to contentSkip to conversation

dt-bindings: arm: Convert PMU binding to json-schema

PATCH New Rob Herring 1 participant 1 message Jan 10, 2019

Subsystems (2)
lore
Share & tools
lore

Rob Herring

author maintainer
#0 lore raw

PATCH v3 1/1 dt-bindings: arm: Convert PMU binding to json-schema

Convert ARM PMU binding to DT schema format using json-schema.

---
v3:
- Don't allow arm,cortex-a15-pmu to be a fallback for arm,cortex-a7-pmu
- Update MAINTAINERS

Will, you can take this.

 Documentation/devicetree/bindings/arm/pmu.txt | 70 ---------------
 .../devicetree/bindings/arm/pmu.yaml          | 87 +++++++++++++++++++
 MAINTAINERS                                   |  2 +-
 3 files changed, 88 insertions(+), 71 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/arm/pmu.txt
 create mode 100644 Documentation/devicetree/bindings/arm/pmu.yaml
Documentation/devicetree/bindings/arm/pmu.txt deleted +0 -70
deleted file mode 100644
index 13611a8199bb..000000000000
@@ -1,70 +0,0 @@
-* ARM Performance Monitor Units
-
-ARM cores often have a PMU for counting cpu and cache events like cache misses
-and hits. The interface to the PMU is part of the ARM ARM. The ARM PMU
-representation in the device tree should be done as under:-
-
-Required properties:
-
-- compatible : should be one of
-	"apm,potenza-pmu"
-	"arm,armv8-pmuv3"
-	"arm,cortex-a73-pmu"
-	"arm,cortex-a72-pmu"
-	"arm,cortex-a57-pmu"
-	"arm,cortex-a53-pmu"
-	"arm,cortex-a35-pmu"
-	"arm,cortex-a17-pmu"
-	"arm,cortex-a15-pmu"
-	"arm,cortex-a12-pmu"
-	"arm,cortex-a9-pmu"
-	"arm,cortex-a8-pmu"
-	"arm,cortex-a7-pmu"
-	"arm,cortex-a5-pmu"
-	"arm,arm11mpcore-pmu"
-	"arm,arm1176-pmu"
-	"arm,arm1136-pmu"
-	"brcm,vulcan-pmu"
-	"cavium,thunder-pmu"
-	"qcom,scorpion-pmu"
-	"qcom,scorpion-mp-pmu"
-	"qcom,krait-pmu"
-- interrupts : 1 combined interrupt or 1 per core. If the interrupt is a per-cpu
-               interrupt (PPI) then 1 interrupt should be specified.
-
-Optional properties:
-
-- interrupt-affinity : When using SPIs, specifies a list of phandles to CPU
-                       nodes corresponding directly to the affinity of
-		       the SPIs listed in the interrupts property.
-
-                       When using a PPI, specifies a list of phandles to CPU
-		       nodes corresponding to the set of CPUs which have
-		       a PMU of this type signalling the PPI listed in the
-		       interrupts property, unless this is already specified
-		       by the PPI interrupt specifier itself (in which case
-		       the interrupt-affinity property shouldn't be present).
-
-                       This property should be present when there is more than
-		       a single SPI.
-
-
-- qcom,no-pc-write : Indicates that this PMU doesn't support the 0xc and 0xd
-                     events.
-
-- secure-reg-access : Indicates that the ARMv7 Secure Debug Enable Register
-		      (SDER) is accessible. This will cause the driver to do
-		      any setup required that is only possible in ARMv7 secure
-		      state. If not present the ARMv7 SDER will not be touched,
-		      which means the PMU may fail to operate unless external
-		      code (bootloader or security monitor) has performed the
-		      appropriate initialisation. Note that this property is
-		      not valid for non-ARMv7 CPUs or ARMv7 CPUs booting Linux
-		      in Non-secure state.
-
-Example:
-
-pmu {
-        compatible = "arm,cortex-a9-pmu";
-        interrupts = <100 101>;
-};
Documentation/devicetree/bindings/arm/pmu.yaml new file +87 -0

87 lines not on this page · raw message

MAINTAINERS +1 -1
index 39fcdbf38969..3f15010e5883 100644
@@ -1159,7 +1159,7 @@ F:	arch/arm*/include/asm/hw_breakpoint.h
 F:	arch/arm*/include/asm/perf_event.h
 F:	drivers/perf/*
 F:	include/linux/perf/arm_pmu.h
-F:	Documentation/devicetree/bindings/arm/pmu.txt
+F:	Documentation/devicetree/bindings/arm/pmu.yaml
 F:	Documentation/devicetree/bindings/perf/
 
 ARM PORT
Signature · 1 line
2.19.1