Skip to contentSkip to conversation

Probing flash before Env setup (Env in UBI)

U-Boot Dominik Vogt 1 participant 1 message Jan 29, 2019

lore
Share & tools
lore
#0 lore raw

Hi folks,

I'm new to uboot and couldn't figure out how to get "CONFIG_ENV_IS_IN_UBI" to work (on a nor flash) yet.

Basically, ubi and ubifs work fine. The mtd device (a nor flash) is supported and works. It is formatted with ubiformat and contains two volumes with a ubifs on each of them.

The "partition" is named "nor0" and the volumes are "env-uboot" and "env-uboot-redund".

--

Now, when the board boots, it tries to load the envorinment and fails:

-- snip --
Loading Environment from SPI Flash... SF: Detected n25q128 with page size 256 Bytes, erase size 64 KiB, total 16 MiB *** Warning - bad CRC, using default environment

Loading Environment from UBI... Partition nor0 not found!

** Cannot find mtd partition "nor0"
-- snip --

The first line looks like the output from "sf probe", but "mtd list" just says:

List of MTD devices:
No MTD device found

Well, I guess I just have to run

sf probe
ubi part nor0

before loading he environment, but I couldn't figure out how to do that, except by adding some C code to board_init_f().

Ciao

Dominik ^_^ ^_^

Signature · 1 line
Dominik Vogt