ARM: mvebu: x530: use MV_DDR_FREQ_SAR
PATCH 1/1 ARM: mvebu: x530: use MV_DDR_FREQ_SAR
MV_DDR_FREQ_SAR lets the DDR frequency be determined by hardware strapping. This also has the side effect of running the DDR clock in synchronous mode with the CPU core clock rather than from an independent PLL. We've seen this improve reliability in operation across a number of boards and temperature ranges.
---
board/alliedtelesis/x530/x530.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
board/alliedtelesis/x530/x530.c +1 -1
@@ -57,7 +57,7 @@ static struct mv_ddr_topology_map board_topology_map = {SPEED_BIN_DDR_1866M ,/* speed_bin */ MV_DDR_DEV_WIDTH_16BIT ,/* sdram device width */ MV_DDR_DIE_CAP_4GBIT ,/* die capacity */ -MV_DDR_FREQ_933 ,/* frequency */ +MV_DDR_FREQ_SAR ,/* frequency */ 0 ,0 ,/* cas_l cas_wl */ MV_DDR_TEMP_LOW ,/* temperature */ MV_DDR_TIM_2T} }, /* timing */
Signature · 1 line
2.20.1
PATCH 1/1 ARM: mvebu: x530: use MV_DDR_FREQ_SAR
Quoted 18 lines · Chris Packham
MV_DDR_FREQ_SARlets the DDR frequency be determined by hardware strapping. This also has the side effect of running the DDR clock in synchronous mode with the CPU core clock rather than from an independent PLL. We've seen this improve reliability in operation across a number of boards and temperature ranges.Signed-off-by Chris Packham <[email protected]>---
board/alliedtelesis/x530/x530.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)board/alliedtelesis/x530/x530.c +0
-0
board/alliedtelesis/x530/x530.c static struct mv_ddr_topology_map board_topology_map = { · line 63
Quoted 8 lines
board/alliedtelesis/x530/x530.c +1
-1@@ -57,7 +57,7 @@ static struct mv_ddr_topology_map board_topology_map = {SPEED_BIN_DDR_1866M ,/* speed_bin */ MV_DDR_DEV_WIDTH_16BIT ,/* sdram device width */ MV_DDR_DIE_CAP_4GBIT ,/* die capacity */ -MV_DDR_FREQ_933 ,/* frequency */ +MV_DDR_FREQ_SAR ,/* frequency */ 0 ,0 ,/* cas_l cas_wl */ MV_DDR_TEMP_LOW ,/* temperature */ MV_DDR_TIM_2T} }, /* timing */
Thanks,
Stefan
PATCH 1/1 ARM: mvebu: x530: use MV_DDR_FREQ_SAR
In reply to Chris PackhamQuoted 7 lines · Chris Packham
MV_DDR_FREQ_SARlets the DDR frequency be determined by hardware strapping. This also has the side effect of running the DDR clock in synchronous mode with the CPU core clock rather than from an independent PLL. We've seen this improve reliability in operation across a number of boards and temperature ranges.Signed-off-by Chris Packham <[email protected]>
Applied to u-boot-marvell/master
Thanks,
Stefan