Skip to contentSkip to conversation

IKVM on AST2400

DISCUSSION Alexander A. Filippov 2 participants 2 messages May 24, 2019 – May 27, 2019

lore
Share & tools
lore
#0 lore raw

Some time ago the obmc-ikvm service was added to the firmware. It causes some problems on our VESNIN hardware. As it based on AST2400 it does not have support for IKVM in the DTS. The system log contains messages that create_usbhid.sh is unable to find some items in the sysfs and then obmc-ikvm service crashes. It causes fail in QEMU_CI test.

I belive that this issue also present on other platforms based on AST2400.

IBM Guys: Do you run tests for Palmetto?
Is there anybody else who uses AST2400?

Well, my proposal is to make the IKVM support optional by moving it to the distrofeature.

Besides, I've solved these problems for our hardware by adding required kernel modules and modifying DTS.
IKVM works, but bring a lot of warnings after the host was shut down while the VNC-client is still connected.

During the solving I copied some records from aspeed-g5.dtsi to aspeed-g4.dtsi. Should I commit these changes to Torvalds or OpenBMC repo?

--
Regards
Alexander Filippov
Software Engineer, YADRO

#1 lore raw

Hi Alexander,

Quoted 11 lines · Alexander A. Filippov

Some time ago the obmc-ikvm service was added to the firmware. It causes some problems on our VESNIN hardware. As it based on AST2400 it does not have support for IKVM in the DTS. The system log contains messages that create_usbhid.sh is unable to find some items in the sysfs and then obmc-ikvm service crashes. It causes fail in QEMU_CI test.

I belive that this issue also present on other platforms based on AST2400.

IBM Guys: Do you run tests for Palmetto?
Is there anybody else who uses AST2400?

I am not sure that anyone has tested it on ast2400. If it works, we can enable it for palmetto.

Quoted 11 lines

Well, my proposal is to make the IKVM support optional by moving it to the distrofeature.

Besides, I've solved these problems for our hardware by adding required kernel modules and modifying DTS.
IKVM works, but bring a lot of warnings after the host was shut down while the VNC-client is still connected.

During the solving I copied some records from aspeed-g5.dtsi to aspeed-g4.dtsi. Should I commit these changes to Torvalds or OpenBMC repo?

Send them to mainline (Torvalds).

Thanks,

Joel