regulator: bd718x7: support ROHM BD71837 and BD71847 PMICs
PATCH v4 2/2 regulator: bd718x7: support ROHM BD71837 and BD71847 PMICs
Quoted 17 lines
BD71837 and BD71847 is PMIC intended for powering single-core, dual-core, and quad-core SoC’s such as NXP-i.MX 8M. BD71847 is used for example on NXP imx8mm EVK.
Add regulator driver for ROHM BD71837 and BD71847 PMICs. BD71837 contains 8 bucks and 7 LDOS. BD71847 is reduced version containing 6 bucks and 6 LDOs. Voltages for DVS bucks (1-4 on BD71837, 1 and 2 on BD71847) can be adjusted when regulators are enabled. For other bucks and LDOs we may have over- or undershooting if voltage is adjusted when regulator is enabled. Thus this is prevented by default. BD718x7 has a quirk which may leave power output disabled after reset if enable/disable state was controlled by SW. Thus the SW control is only allowed for BD71837 bucks 3 and 4 by default. The impact of this limitation must be evaluated board-by board and restrictions may need to be modified. (Linux driver get's these limitations from DT and we may want to implement same on u-Boot driver).
Quoted 2 lines
Signed-off-by Matti Vaittinen <[email protected]>Reviewed-by Simon Glass <[email protected]>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================