ARM: dts: sun8i: a83t: Enable HDMI output on Cubietruck Plus
Subsystems (2)
Chen-Yu Tsai
maintainerPATCH 1/1 ARM: dts: sun8i: a83t: Enable HDMI output on Cubietruck Plus
From: Chen-Yu Tsai <[email protected]>
The Cubietruck Plus has an HDMI connector tied to the HDMI output of the SoC.
Enables display output via HDMI on the Cubietruck Plus. The connector device node is named "hdmi-connector" as there is also a display port connector, which is tied to the MIPI DSI output of the SoC through a MIPI-DSI-to-DP bridge. This part is not supported yet.
--- .../boot/dts/sun8i-a83t-cubietruck-plus.dts | 25 +++++++++++++++++++ 1 file changed, 25 insertions(+)
arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts +25 -0
@@ -60,6 +60,17 @@ stdout-path = "serial0:115200n8"; }; + hdmi-connector { + compatible = "hdmi-connector"; + type = "a"; + + port { + hdmi_con_in: endpoint { + remote-endpoint = <&hdmi_out_con>; + }; + }; + }; + leds { compatible = "gpio-leds";
@@ -153,6 +164,10 @@ cpu-supply = <®_dcdc3>; }; +&de { + status = "okay"; +}; + &ehci0 { /* GL830 USB-to-SATA bridge here */ status = "okay";
@@ -172,6 +187,16 @@ status = "okay"; }; +&hdmi { + status = "okay"; +}; + +&hdmi_out { + hdmi_out_con: endpoint { + remote-endpoint = <&hdmi_con_in>; + }; +}; + &mdio { rgmii_phy: ethernet-phy@1 { compatible = "ethernet-phy-ieee802.3-c22";
Signature · 1 line
2.20.1
Quoted 6 lines · Chen-Yu Tsai
From: Chen-Yu Tsai <[email protected]>
The Cubietruck Plus has an HDMI connector tied to the HDMI output of the SoC.
Quoted 6 lines
Enables display output via HDMI on the Cubietruck Plus. The connector device node is named "hdmi-connector" as there is also a display port connector, which is tied to the MIPI DSI output of the SoC through a MIPI-DSI-to-DP bridge. This part is not supported yet.
Signed-off-by Chen-Yu Tsai <[email protected]>
Applied for 5.4.