PCI: rcar: Move the inbound index check
Subsystems (4)
PATCH v2 1/3 PCI: rcar: Move the inbound index check
From: Marek Vasut <[email protected]>
Since the $idx variable value is stored across multiple calls to rcar_pcie_inbound_ranges() function, and the $idx value is used to index registers which are written, subsequent calls might cause the $idx value to be high enough to trigger writes into nonexistent registers.
Fix this by moving the $idx value check to the beginning of the loop.
To: [email protected]
---
V2: New patch
--- drivers/pci/controller/pcie-rcar.c | 9 ++++----- 1 file changed, 4 insertions(+), 5 deletions(-)
drivers/pci/controller/pcie-rcar.c +4 -5
@@ -1048,6 +1048,10 @@ static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie, mask &= ~0xf ;while (cpu_addr < cpu_end) { +if (idx >MAX_NR_INBOUND_MAPS ) { +dev_err (pcie->dev,"Failed to map inbound regions!\n" ); +return -EINVAL ; + }/* * Set up 64-bit inbound regions as the range parser doesn't * distinguish between 32 and 64-bit types.
@@ -1067,11 +1071,6 @@ static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie, pci_addr += size; cpu_addr += size; idx +=2 ; - -if (idx >MAX_NR_INBOUND_MAPS ) { -dev_err (pcie->dev,"Failed to map inbound regions!\n" ); -return -EINVAL ; - } } *index = idx;
Signature · 1 line
2.20.1
PATCH v2 2/3 PCI: rcar: Do not abort on too many inbound dma-ranges
From: Marek Vasut <[email protected]>
In case the "dma-ranges" DT property contains either too many ranges or the range start address is unaligned in such a way that populating the range into the controller requires multiple entries, a situation may occur where all ranges cannot be loaded into the controller.
Currently, the driver refuses to probe in such a situation. Relax this behavior, load as many ranges as possible and warn if some ranges do not fit anymore.
To: [email protected]
---
V2: Update on top of 1/3
--- drivers/pci/controller/pcie-rcar.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
drivers/pci/controller/pcie-rcar.c +3 -2
@@ -1049,8 +1049,9 @@ static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie,while (cpu_addr < cpu_end) {if (idx >MAX_NR_INBOUND_MAPS ) { -dev_err (pcie->dev,"Failed to map inbound regions!\n" ); -return -EINVAL ; +dev_warn (pcie->dev, +"Too many inbound regions, not all are mapped.\n" ); +break ; }/* * Set up 64-bit inbound regions as the range parser doesn't
Signature · 1 line
2.20.1
PATCH v2 3/3 PCI: rcar: Recalculate inbound range alignment for each controller entry
In reply to [email protected]From: Marek Vasut <[email protected]>
Due to hardware constraints, the size of each inbound range entry populated into the controller cannot be larger than the alignment of the entry's start address. Currently, the alignment for each "dma-ranges" inbound range is calculated only once for each range and the increment for programming the controller is also derived from it only once. Thus, a "dma-ranges" entry describing a memory at 0x48000000 and size 0x38000000 would lead to multiple controller entries, each 0x08000000 long.
This is inefficient, especially considering that by adding the size to the start address, the alignment increases. This patch moves the alignment calculation into the loop populating the controller entries, thus updating the alignment for each controller entry.
---
V2: Update on top of 1/3
--- drivers/pci/controller/pcie-rcar.c | 37 +++++++++++++++--------------- 1 file changed, 19 insertions(+), 18 deletions(-)
drivers/pci/controller/pcie-rcar.c +19 -18
@@ -1029,30 +1029,31 @@ static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie,if (restype &IORESOURCE_PREFETCH ) flags |=LAM_PREFETCH ; -/* -* If the size of the range is larger than the alignment of the start -* address, we have to use multiple entries to perform the mapping. -*/ -if (cpu_addr >0 ) { -unsigned long nr_zeros =__ffs64 (cpu_addr); -u64 alignment =1ULL << nr_zeros; - - size =min (range->size, alignment); - }else { - size = range->size; - } -/* Hardware supports max 4GiB inbound region */ - size =min (size,1ULL <<32 ); - - mask =roundup_pow_of_two (size) -1 ; - mask &= ~0xf ; -while (cpu_addr < cpu_end) {if (idx >MAX_NR_INBOUND_MAPS ) {dev_warn (pcie->dev,"Too many inbound regions, not all are mapped.\n" );break ; } +/* +* If the size of the range is larger than the alignment of +* the start address, we have to use multiple entries to +* perform the mapping. +*/ +if (cpu_addr >0 ) { +unsigned long nr_zeros =__ffs64 (cpu_addr); +u64 alignment =1ULL << nr_zeros; + + size =min (range->size, alignment); + }else { + size = range->size; + } +/* Hardware supports max 4GiB inbound region */ + size =min (size,1ULL <<32 ); + + mask =roundup_pow_of_two (size) -1 ; + mask &= ~0xf ; +/* * Set up 64-bit inbound regions as the range parser doesn't * distinguish between 32 and 64-bit types.
Signature · 1 line
2.20.1
Hi Marek,
Quoted 11 lines · On Fri, Aug 9, 2019 at 7:48 PM <[email protected]> wrote:
From: Marek Vasut <[email protected]>
Since the $idx variable value is stored across multiple calls to
rcar_pcie_inbound_ranges()function, and the $idx value is used to index registers which are written, subsequent calls might cause the $idx value to be high enough to trigger writes into nonexistent registers.Fix this by moving the $idx value check to the beginning of the loop.
Signed-off-by Marek Vasut <[email protected]>
Thanks for your patch!
drivers/pci/controller/pcie-rcar.c static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie, · line 1051
Quoted 7 lines
drivers/pci/controller/pcie-rcar.c +1
-0@@ -1048,6 +1048,10 @@ static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie, mask &= ~0xf ;while (cpu_addr < cpu_end) { +if (idx >MAX_NR_INBOUND_MAPS ) {
Shouldn't that check be "idx >= MAX_NR_INBOUND_MAPS - 1" now?
Quoted 7 lines
drivers/pci/controller/pcie-rcar.c +3
-0+dev_err (pcie->dev,"Failed to map inbound regions!\n" ); +return -EINVAL ; + }/* * Set up 64-bit inbound regions as the range parser doesn't * distinguish between 32 and 64-bit types.
drivers/pci/controller/pcie-rcar.c static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie, · line 1075
Quoted 10 lines
drivers/pci/controller/pcie-rcar.c +0
-5@@ -1067,11 +1071,6 @@ static int rcar_pcie_inbound_ranges(struct rcar_pcie *pcie, pci_addr += size; cpu_addr += size; idx +=2 ; - -if (idx >MAX_NR_INBOUND_MAPS ) { -dev_err (pcie->dev,"Failed to map inbound regions!\n" ); -return -EINVAL ; - } } *index = idx;
Gr{oetje,eeting}s,
Geert
Signature · 5 lines
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected] In personal conversations with technical people, I call myself a hacker. But when I'm talking to journalists I just say "programmer" or something like that. -- Linus Torvalds