ARM: omapl138_lcdk: Remove dead RMII code
PATCH 1/1 ARM: omapl138_lcdk: Remove dead RMII code
The omapl138-lcdk does not need to care about RMII code. It appears to be more legacy code when branched from the da850-evm. This patch removes the #ifdefs and #defines related to the enabling/disabling and checking for that option.
Signed-off-by Adam Ford <[email protected]>
board/davinci/da8xxevm/omapl138_lcdk.c +1 -24
@@ -108,12 +108,6 @@ const struct pinmux_config nand_pins[] = {#endif -#ifdef CONFIG_DRIVER_TI_EMAC_USE_RMII -#define HAS_RMII 1 -#else -#define HAS_RMII 0 -#endif -const struct pinmux_resource pinmuxes[] = {PINMUX_ITEM (uart_pins),PINMUX_ITEM (i2c_pins),
@@ -216,7 +210,7 @@ int board_init(void)#ifdef CONFIG_DRIVER_TI_EMAC if (davinci_configure_pin_mux (emac_pins,ARRAY_SIZE (emac_pins)) !=0 )return 1 ; -davinci_emac_mii_mode_sel (HAS_RMII ); +davinci_emac_mii_mode_sel (0 );#endif /* CONFIG_DRIVER_TI_EMAC */ /* enable the console UART */
@@ -289,17 +283,6 @@ static void dspwake(void)REG (PSC0_MDCTL + (15 *4 )) |=0x100 ; } -#ifdef CONFIG_DRIVER_TI_EMAC_USE_RMII -/** -* rmii_hw_init -* -*/ -int rmii_hw_init (void ) -{ -return 0 ; -} -#endif /* CONFIG_DRIVER_TI_EMAC_USE_RMII */ -int misc_init_r (void ) {uint8_t tmp[20 ], addr[10 ];
@@ -325,12 +308,6 @@ int misc_init_r(void) } } -#ifdef CONFIG_DRIVER_TI_EMAC_USE_RMII -/* Select RMII fucntion through the expander */ -if (rmii_hw_init ()) -printf ("RMII hardware init failed!!!\n" ); -#endif -dspwake ();return 0 ;
Signature · 1 line
2.17.1