Skip to contentSkip to conversation

cmd: mdio/mii: add Kconfig help and allow break dependency

PATCH New Ramon Fried 2 participants 2 messages Sep 13, 2019

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 cmd: mdio/mii: add Kconfig help and allow break dependency

* Add Kconfig help describing the purpose of each command.
* Add CONFIG_CMD_MDIO so it could be selected individually, as it doesn't depend on the mii command.
* Add Kconfig imply to mii to automatically select the mdio command.

---
 cmd/Kconfig  | 18 ++++++++++++++++--
 cmd/Makefile |  4 +---
 2 files changed, 17 insertions(+), 5 deletions(-)
cmd/Kconfig +16 -2
index 98647f58b7..cfb3b58119 100644
@@ -1410,8 +1410,22 @@ config CMD_NFS
 
 config CMD_MII
 	bool "mii"
-	help
-	  Enable MII utility commands.
+	imply CMD_MDIO
+	help
+	  If set, allows 802.3(clause 22) MII Management functions interface access
+	  The management interface specified in Clause 22 provides
+	  a simple, two signal, serial interface to connect a
+	  Station Management entity and a managed PHY for providing access
+	  to management parameters and services.
+	  The interface is referred to as the MII management interface.
+
+config CMD_MDIO
+	bool "mdio"
+	depends on PHYLIB
+	help
+	  If set, allows Enable 802.3(clause 45) MDIO interface registers access
+	  The MDIO interface is orthogonal to the MII interface and extends
+	  it by adding access to more registers through indirect addressing.
 
 config CMD_PING
 	bool "ping"
cmd/Makefile +1 -3
index ac843b4b16..384ddb8eaf 100644
@@ -89,9 +89,7 @@ obj-$(CONFIG_CMD_MEMORY) += mem.o
 obj-$(CONFIG_CMD_IO) += io.o
 obj-$(CONFIG_CMD_MFSL) += mfsl.o
 obj-$(CONFIG_CMD_MII) += mii.o
-ifdef CONFIG_PHYLIB
-obj-$(CONFIG_CMD_MII) += mdio.o
-endif
+obj-$(CONFIG_CMD_MDIO) += mdio.o
 obj-$(CONFIG_CMD_MISC) += misc.o
 obj-$(CONFIG_CMD_MMC) += mmc.o
 obj-$(CONFIG_MP) += mp.o
Signature · 1 line
2.23.0
#1 lore raw

PATCH 1/1 cmd: mdio/mii: add Kconfig help and allow break dependency

Quoted 8 lines · Ramon Fried

* Add Kconfig help describing the purpose of each command.
* Add CONFIG_CMD_MDIO so it could be selected individually, as it doesn't depend on the mii command.
* Add Kconfig imply to mii to automatically select the mdio command.