phy: mapphone-mdm6600: Fix timeouts by adding wake-up handling
Subsystems (2)
PATCH 1/1 phy: mapphone-mdm6600: Fix timeouts by adding wake-up handling
We have an interrupt handler for the wake-up GPIO pin, but we're missing the code to wake-up the system. This can cause timeouts receiving data for the UART that shares the wake-up GPIO pin with the USB PHY.
All we need to do is just wake the system and kick the autosuspend timeout to fix the issue.
Fixes 5d1ebbda0318 ("phy: mapphone-mdm6600: Add USB PHY driver for MDM6600 on Droid 4")
Cc Marcel Partap <[email protected]>
Cc Merlijn Wajer <[email protected]>
Cc Michael Scott <[email protected]>
Cc NeKit <[email protected]>
Cc Pavel Machek <[email protected]>
Cc Sebastian Reichel <[email protected]>
Signed-off-by Tony Lindgren <[email protected]>
--- drivers/phy/motorola/phy-mapphone-mdm6600.c | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-)
drivers/phy/motorola/phy-mapphone-mdm6600.c +16 -2
@@ -243,10 +243,24 @@ static irqreturn_t phy_mdm6600_wakeirq_thread(int irq, void *data) {struct phy_mdm6600 *ddata = data;struct gpio_desc *mode_gpio1; +int error, wakeup; mode_gpio1 = ddata->mode_gpios->desc[PHY_MDM6600_MODE1 ]; -dev_dbg (ddata->dev,"OOB wake on mode_gpio1: %i\n" , -gpiod_get_value (mode_gpio1)); + wakeup =gpiod_get_value (mode_gpio1); +if (!wakeup) +return IRQ_NONE ; + +dev_dbg (ddata->dev,"OOB wake on mode_gpio1: %i\n" , wakeup); + error =pm_runtime_get_sync (ddata->dev); +if (error <0 ) { +pm_runtime_put_noidle (ddata->dev); + +return IRQ_NONE ; + } + +/* Just wake-up and kick the autosuspend timer */ +pm_runtime_mark_last_busy (ddata->dev); +pm_runtime_put_autosuspend (ddata->dev);return IRQ_HANDLED ; }
Signature · 1 line
2.23.0