thermal: sun8i: remove unused variable and unneeded macros
Subsystems (3)
Yangtao Li
maintainerPATCH 1/1 thermal: sun8i: remove unused variable and unneeded macros
The cp_ft_flag variable is not used after initialization, so delete it. After that, THS_EFUSE_CP_FT_MASK, THS_EFUSE_CP_FT_BIT and THS_CALIBRATION_IN_FT are not needed, so delete them.
Signed-off-by Yangtao Li <[email protected]>
--- drivers/thermal/sun8i_thermal.c | 6 ------ 1 file changed, 6 deletions(-)
drivers/thermal/sun8i_thermal.c +0 -6
@@ -54,9 +54,6 @@#define SUN50I_H6_THS_DATA_IRQ_STS (x) BIT(x)/* millidegree celsius */ -#define THS_EFUSE_CP_FT_MASK 0x3000 -#define THS_EFUSE_CP_FT_BIT 12 -#define THS_CALIBRATION_IN_FT 1struct tsensor {struct ths_device *tmdev;
@@ -88,7 +85,6 @@ struct ths_device {struct clk *bus_clk;struct clk *mod_clk;struct tsensor sensor[MAX_SENSOR_NUM ]; -u32 cp_ft_flag; };/* Temp Unit: millidegree Celsius */
@@ -244,8 +240,6 @@ static int sun50i_h6_ths_calibrate(struct ths_device *tmdev,* register values and this will become a calibration offset. */ ft_temp = (caldata[0 ] &FT_TEMP_MASK ) *100 ; - tmdev->cp_ft_flag = (caldata[0 ] &THS_EFUSE_CP_FT_MASK ) - >>THS_EFUSE_CP_FT_BIT ;for (i =0 ; i < tmdev->chip->sensor_num; i++) {int sensor_reg = caldata[i +1 ];
Signature · 1 line
2.17.1
Daniel Lezcano
AppliedQuoted 6 lines · Yangtao Li
The
cp_ft_flagvariable is not used after initialization, so delete it. After that,THS_EFUSE_CP_FT_MASK,THS_EFUSE_CP_FT_BITandTHS_CALIBRATION_IN_FTare not needed, so delete them.Signed-off-by Yangtao Li <[email protected]>---
Applied, thanks
Signature · 5 lines
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook | <http://twitter.com/#!/linaroorg> Twitter | <http://www.linaro.org/linaro-blog/> Blog