Skip to contentSkip to conversation

hwmon: (nct7904) Add to read all of the SMI status registers in probe function.

PATCH Guenter Roeck 1 participant 1 message May 13, 2020 Hardware monitoring

lore
Share & tools
lore

Guenter Roeck

author maintainer Applied
#0 lore raw
Quoted 9 lines · On Tue, May 12, 2020 at 02:25:23AM +0000, [email protected] wrote:

From: Amy Shih <[email protected]>

When nct7904 power up, it compares current sensor readings within the default threshold immediately, thus some of SMI status registers would get non zero values cause the false alarms on first reading. Add to read all of the SMI status registers in probe function to clear the alarms.

Applied.

Thanks,
Guenter

Quoted 33 lines
---
 drivers/hwmon/nct7904.c | 8 ++++++++
 1 file changed, 8 insertions(+)
drivers/hwmon/nct7904.c +8 -0
index 571a649..6fb06f7 100644
@@ -45,6 +45,7 @@
 #define FANCTL_MAX		4	/* Counted from 1 */
 #define TCPU_MAX		8	/* Counted from 1 */
 #define TEMP_MAX		4	/* Counted from 1 */
+#define SMI_STS_MAX		10	/* Counted from 1 */
 
 #define VT_ADC_CTRL0_REG	0x20	/* Bank 0 */
 #define VT_ADC_CTRL1_REG	0x21	/* Bank 0 */
@@ -1126,6 +1127,13 @@ static int nct7904_probe(struct i2c_client *client,
 		data->fan_mode[i] = ret;
 	}
 
+	/* Read all of SMI status register to clear alarms */
+	for (i = 0; i < SMI_STS_MAX; i++) {
+		ret = nct7904_read_reg(data, BANK_0, SMI_STS1_REG + i);
+		if (ret < 0)
+			return ret;
+	}
+
 	hwmon_dev =
 		devm_hwmon_device_register_with_info(dev, client->name, data,
 						     &nct7904_chip_info, NULL);
Signature · 1 line
1.8.3.1