Skip to contentSkip to conversation

ARM: dts: imx6qdl-sabresd: Pass phy-reset-duration

PATCH New Fabio Estevam 1 participant 2 messages Jun 17, 2020

Subsystems (2)
lore
Share & tools
lore

Fabio Estevam

author reviewer
#0 lore raw

PATCH 1/2 ARM: dts: imx6qdl-sabresd: Pass phy-reset-duration

According to the AR8031 datasheet:

"When using crystal, clock is generated internally after the power is stable. In order to get reliable power-on-reset, it is recommended to keep asserting the reset low signal long enough (10 ms) to ensure the clock is stable and clock-to-reset (1 ms) requirement is satisfied."

Pass the 'phy-reset-duration' property to meet such requirement.

---
 arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 1 +
 1 file changed, 1 insertion(+)
arch/arm/boot/dts/imx6qdl-sabresd.dtsi +1 -0
index 28b35ccb3757..9697211b7693 100644
@@ -204,6 +204,7 @@
 	pinctrl-0 = <&pinctrl_enet>;
 	phy-mode = "rgmii-id";
 	phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
+	phy-reset-duration = <10>;
 	fsl,magic-packet;
 	status = "okay";
 };
Signature · 7 lines
2.17.1


_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
author reviewer
#1 lore raw

PATCH 2/2 ARM: dts: imx6qdl-sabresd: Add an mdio node

imx6qdl-sabresd has an Atheros AR8031 Ethernet PHY at address 1.

The AR8031 provides a 125MHz clock to the ENET_REF_CLK i.MX6 pin.

Improve the Ethernet representation by adding an mdio node with such information.

An advantage of adding the mdio node is that the AR8031 initialization code in the mx6sabresd board file in U-Boot can totally be removed.

---
 arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 11 +++++++++++
 1 file changed, 11 insertions(+)
arch/arm/boot/dts/imx6qdl-sabresd.dtsi +11 -0
index 9697211b7693..fb70ae0811af 100644
@@ -203,10 +203,21 @@
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_enet>;
 	phy-mode = "rgmii-id";
+	phy-handle = <&phy>;
 	phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
 	phy-reset-duration = <10>;
 	fsl,magic-packet;
 	status = "okay";
+
+	mdio {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		phy: ethernet-phy@1 {
+			reg = <1>;
+			qca,clk-out-frequency = <125000000>;
+		};
+	};
 };
 
 &hdmi {
Signature · 7 lines
2.17.1


_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel