habanalabs: increase h/w timer when checking idle
PATCH 1/1 habanalabs: increase h/w timer when checking idle
From: Omer Shpigelman <[email protected]>
In GAUDI the current timer value for the hardware to check if it is in IDLE state is too low. As a result, there are occasions where the H/W wrongly reports it is not IDLE. The driver checks that before submitting work on behalf of the driver during initialization, so a false report might cause the driver to fail during device initialization.
Signed-off-by Omer Shpigelman <[email protected]>
Signed-off-by Oded Gabbay <[email protected]>
--- drivers/misc/habanalabs/gaudi/gaudi.c | 2 ++ 1 file changed, 2 insertions(+)
drivers/misc/habanalabs/gaudi/gaudi.c +2 -0
@@ -1893,6 +1893,8 @@ static void gaudi_init_pci_dma_qman(struct hl_device *hdev, int dma_id,WREG32 (mmDMA0_QM_CP_MSG_BASE3_ADDR_LO_0 + q_off, so_base_ws_lo);WREG32 (mmDMA0_QM_CP_MSG_BASE3_ADDR_HI_0 + q_off, so_base_ws_hi); +WREG32 (mmDMA0_QM_CP_BARRIER_CFG_0 + q_off,0x100 ); +/* The following configuration is needed only once per QMAN */ if (qman_id ==0 ) {/* Configure RAZWI IRQ */
Signature · 1 line
2.17.1