mm-slub-make-remaining-slub_debug-related-attributes-read-only.patch removed from -mm tree
The patch titled
Subject: mm, slub: make remaining slub_debug related attributes read-only
has been removed from the -mm tree. Its filename was
mm-slub-make-remaining-slub_debug-related-attributes-read-only.patch
This patch was dropped because it was merged into mainline or a subsystem tree
------------------------------------------------------
From: Vlastimil Babka <[email protected]>
Subject: mm, slub: make remaining slub_debug related attributes read-only
SLUB_DEBUG creates several files under /sys/kernel/slab/<cache>/ that can be read to check if the respective debugging options are enabled for given cache. Some options, namely sanity_checks, trace, and failslab can be also enabled and disabled at runtime by writing into the files.
The runtime toggling is racy. Some options disable __CMPXCHG_DOUBLE when enabled, which means that in case of concurrent allocations, some can still use __CMPXCHG_DOUBLE and some not, leading to potential corruption. The s->flags field is also not updated or checked atomically. The simplest solution is to remove the runtime toggling. The extended slub_debug boot parameter syntax introduced by earlier patch should allow to fine-tune the debugging configuration during boot with same granularity.
---
Documentation/vm/slub.rst | 7 +--- mm/slub.c | 62 +----------------------------------- 2 files changed, 5 insertions(+), 64 deletions(-)
Documentation/vm/slub.rst renamed from Documentation/vm/slub.rst~mm-slub-make-remaining-slub_debug-related-attributes-read-only +2 -5
@@ -116,11 +116,8 @@ options from the ``slub_debug`` paramete T trace A failslab -The sanity_checks, trace and failslab files are writable, so writing 1 or 0 -will enable or disable the option at runtime. The writes to trace and failslab -may return -EINVAL if the cache is subject to slab merging. Careful with -tracing: It may spew out lots of information and never stop if used on the -wrong slab. +Careful with tracing: It may spew out lots of information and never stop if +used on the wrong slab. Slab merging ============
mm/slub.c renamed from mm/slub.c~mm-slub-make-remaining-slub_debug-related-attributes-read-only +3 -59
85 lines not on this page · raw message
_
Patches currently in -mm which might be from [email protected] are