Skip to contentSkip to conversation

hwmon: (drivetemp) Add usage not describing impact on drive spin-down

PATCH New Guenter Roeck 1 participant 1 message Aug 11, 2020

Subsystems (2)
lore
Share & tools
lore

Guenter Roeck

author maintainer
#0 lore raw

PATCH 1/1 hwmon: (drivetemp) Add usage not describing impact on drive spin-down

On some drives, reading the drive temperature resets the drive's spin-down timer. If the drive temperature is read too often, affected drives will never spin down. Add this information as usage note to the driver documentation.

---
 Documentation/hwmon/drivetemp.rst | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)
Documentation/hwmon/drivetemp.rst +18 -0
index 2d37d049247f..0b1cf2f912c5 100644
@@ -30,6 +30,24 @@ Transport is not supported, the driver uses SMART attributes to read
 the drive temperature.
 
 
+Usage Note
+----------
+
+Reading the drive temperature may reset the spin down timer on some drives.
+This has been observed with WD120EFAX drives, but may be seen with other
+drives as well. The same behavior is observed if the 'hdtemp' or 'smartd'
+tools are used to access the drive.
+With the WD120EFAX drive, reading the drive temperature using the drivetemp
+driver is still possible _after_ it transitioned to standby mode, and
+reading the drive temperature in this mode will not cause the drive to
+change its mode (meaning the drive will not spin up). It is unknown if other
+drives experience similar behavior.
+
+A known workaround for WD120EFAX drives is to read the drive temperature at
+intervals larger than twice the spin-down time. Otherwise affected drives
+will never spin down.
+
+
 Sysfs entries
 -------------
 
Signature · 1 line
2.17.1