Skip to contentSkip to conversation

efi/arm: set HSCTLR Thumb2 bit correctly for HVC calls from HYP

PATCH New Ard Biesheuvel 1 participant 1 message Oct 4, 2020

Subsystems (2)
lore
Share & tools
lore

Ard Biesheuvel

author maintainer
#0 lore raw

PATCH 1/1 efi/arm: set HSCTLR Thumb2 bit correctly for HVC calls from HYP

Commit

db227c19e68db353 ("ARM: 8985/1: efi/decompressor: deal with HYP mode boot gracefully")

updated the EFI entry code to permit firmware to invoke the EFI stub loader in HYP mode, with the MMU either enabled or disabled, neither of which is permitted by the EFI spec, but which does happen in the field.

In the MMU on case, we remain in HYP mode as configured by the firmware, and rely on the fact that any HVC instruction issued in this mode will be dispatched via the SVC slot in the HYP vector table. However, this slot will point to a Thumb2 symbol if the kernel is built in Thumb2 mode, and so we have to configure HSCTLR to ensure that the exception handlers are invoked in Thumb2 mode as well.

Fixes db227c19e68db353 ("ARM: 8985/1: efi/decompressor: deal with HYP mode boot gracefully")
---
 arch/arm/boot/compressed/head.S | 3 +++
 1 file changed, 3 insertions(+)
arch/arm/boot/compressed/head.S +3 -0
index 434a16982e34..19499d636bc8 100644
@@ -1476,6 +1476,9 @@ ENTRY(efi_enter_kernel)
 		@ issued from HYP mode take us to the correct handler code. We
 		@ will disable the MMU before jumping to the kernel proper.
 		@
+ ARM(		bic	r1, r1, #(1 << 30)	) @ clear HSCTLR.TE
+ THUMB(		orr	r1, r1, #(1 << 30)	) @ set HSCTLR.TE
+		mcr	p15, 4, r1, c1, c0, 0
 		adr	r0, __hyp_reentry_vectors
 		mcr	p15, 4, r0, c12, c0, 0	@ set HYP vector base (HVBAR)
 		isb
Signature · 1 line
2.17.1