Skip to contentSkip to conversation

mm: improve mprotect(R|W) efficiency on pages referenced once

PATCH Superseded Peter Collingbourne 2 participants 5 messages Dec 12, 2020 – Dec 30, 2020

Subsystems (2)

v1 of 5 Superseded Latest is v5 →

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 mm: improve mprotect(R|W) efficiency on pages referenced once

In the Scudo memory allocator [1] we would like to be able to detect use-after-free vulnerabilities involving large allocations by issuing mprotect(PROT_NONE) on the memory region used for the allocation when it is deallocated. Later on, after the memory region has been "quarantined" for a sufficient period of time we would like to be able to use it for another allocation by issuing mprotect(PROT_READ|PROT_WRITE).

Before this patch, after removing the write protection, any writes to the memory region would result in page faults and entering the copy-on-write code path, even in the usual case where the pages are only referenced by a single PTE, harming performance unnecessarily. Make it so that any pages in anonymous mappings that are only referenced by a single PTE are immediately made writable during the mprotect so that we can avoid the page faults.

This program shows the critical syscall sequence that we intend to use in the allocator:

  #include <string.h>
  #include <sys/mman.h>

  enum { kSize = 131072 };

  int main(int argc, char **argv) {
    char *addr = (char *)mmap(0, kSize, PROT_READ | PROT_WRITE,
                              MAP_ANONYMOUS | MAP_PRIVATE, -1, 0);
    for (int i = 0; i != 100000; ++i) {
      memset(addr, i, kSize);
      mprotect((void *)addr, kSize, PROT_NONE);
      mprotect((void *)addr, kSize, PROT_READ | PROT_WRITE);
    }
  }

The effect of this patch on the above program was measured on a DragonBoard 845c by taking the median real time execution time of 10 runs.

Before: 3.19s
After:  0.79s

The effect was also measured using one of the microbenchmarks that we normally use to benchmark the allocator [2], after modifying it to make the appropriate mprotect calls [3]. With an allocation size of 131072 bytes to trigger the allocator's "large allocation" code path the per-iteration time was measured as follows:

Before: 33364ns
After: 6886ns

---
 mm/mprotect.c | 6 ++++++
 1 file changed, 6 insertions(+)
mm/mprotect.c +6 -0
index 56c02beb6041..6f5313d66d00 100644
@@ -47,6 +47,8 @@ static unsigned long change_pte_range(struct vm_area_struct *vma, pmd_t *pmd,
 	bool prot_numa = cp_flags & MM_CP_PROT_NUMA;
 	bool uffd_wp = cp_flags & MM_CP_UFFD_WP;
 	bool uffd_wp_resolve = cp_flags & MM_CP_UFFD_WP_RESOLVE;
+	bool anon_writable =
+		vma_is_anonymous(vma) && (vma->vm_flags & VM_WRITE);
 
 	/*
 	 * Can be called with only the mmap_lock for reading by
@@ -136,7 +138,11 @@ static unsigned long change_pte_range(struct vm_area_struct *vma, pmd_t *pmd,
 					(pte_soft_dirty(ptent) ||
 					 !(vma->vm_flags & VM_SOFTDIRTY))) {
 				ptent = pte_mkwrite(ptent);
+			} else if (anon_writable &&
+				   page_mapcount(pte_page(ptent)) == 1) {
+				ptent = pte_mkwrite(ptent);
 			}
+
 			ptep_modify_prot_commit(vma, addr, pte, oldpte, ptent);
 			pages++;
 		} else if (is_swap_pte(oldpte)) {
Signature · 1 line
2.29.2.576.ga3fc446d84-goog
maintainer
#1 lore raw
Quoted 8 lines · On Fri, 11 Dec 2020 21:31:52 -0800 Peter Collingbourne <[email protected]> wrote:

In the Scudo memory allocator [1] we would like to be able to detect use-after-free vulnerabilities involving large allocations by issuing mprotect(PROT_NONE) on the memory region used for the allocation when it is deallocated. Later on, after the memory region has been "quarantined" for a sufficient period of time we would like to be able to use it for another allocation by issuing mprotect(PROT_READ|PROT_WRITE).

Quoted 8 lines

Before this patch, after removing the write protection, any writes to the memory region would result in page faults and entering the copy-on-write code path, even in the usual case where the pages are only referenced by a single PTE, harming performance unnecessarily. Make it so that any pages in anonymous mappings that are only referenced by a single PTE are immediately made writable during the mprotect so that we can avoid the page faults.

I worry that some other application out there does a similar thing, but only expects to very sparsely write to the area. It will see a big increase in mprotect() latency.

Would it be better to implement this as a separate operation, rather than unconditionally tying it into mprotect()? Say, a new madvise() operation?

#2 lore raw
Quoted 20 lines · Andrew Morton
Quoted 8 lines · On Fri, 11 Dec 2020 21:31:52 -0800 Peter Collingbourne <[email protected]> wrote:

In the Scudo memory allocator [1] we would like to be able to detect use-after-free vulnerabilities involving large allocations by issuing mprotect(PROT_NONE) on the memory region used for the allocation when it is deallocated. Later on, after the memory region has been "quarantined" for a sufficient period of time we would like to be able to use it for another allocation by issuing mprotect(PROT_READ|PROT_WRITE).

Quoted 8 lines

Before this patch, after removing the write protection, any writes to the memory region would result in page faults and entering the copy-on-write code path, even in the usual case where the pages are only referenced by a single PTE, harming performance unnecessarily. Make it so that any pages in anonymous mappings that are only referenced by a single PTE are immediately made writable during the mprotect so that we can avoid the page faults.

Quoted 7 lines

I worry that some other application out there does a similar thing, but only expects to very sparsely write to the area. It will see a big increase in mprotect() latency.

Would it be better to implement this as a separate operation, rather than unconditionally tying it into mprotect()? Say, a new madvise() operation?

So the case that you're concerned about would be highlighted by this program, correct?

#include <string.h>
#include <sys/mman.h>

enum { kSize = 131072 };

int main(int argc, char **argv) {
char *addr = (char *)mmap(0, kSize, PROT_READ | PROT_WRITE,

                            MAP_ANONYMOUS | MAP_PRIVATE, -1, 0);
  memset(addr, 1, kSize);
  for (int i = 0; i != 100000; ++i) {
    mprotect((void *)addr, kSize, PROT_NONE);
    mprotect((void *)addr, kSize, PROT_READ | PROT_WRITE);

}
}

I measured the before/after real time execution time of this program (median of 100 runs) on the DragonBoard and the results were:

Before: 0.325928s
After: 0.365493s

So there's an increase of around 12%. It doesn't seem very large to me when compared to the 400-500% improvement that we get in the case where every page is touched.

I also tried this program to measure the impact in the case where a single page is touched after the mprotect:

#include <string.h>
#include <sys/mman.h>

enum { kSize = 131072 };

int main(int argc, char **argv) {
char *addr = (char *)mmap(0, kSize, PROT_READ | PROT_WRITE,

                            MAP_ANONYMOUS | MAP_PRIVATE, -1, 0);
  memset(addr, 1, kSize);
  for (int i = 0; i != 100000; ++i) {
    memset(addr + (i * 4096) % kSize, i, 4096);
    mprotect((void *)addr, kSize, PROT_NONE);
    mprotect((void *)addr, kSize, PROT_READ | PROT_WRITE);

}
}

With this program the numbers were:

Before: 0.441516s
After: 0.380251s

So it seems that even with a single page fault the new approach is faster.

I saw similar results if I adjusted the programs to use a larger mapping size. With kSize = 1048576 I get these numbers for the first program:

Before: 1.563078s
After: 1.607476s

i.e. around 3%.

And these for the second:

Before: 1.684663s
After: 1.683272s

i.e. about the same.

What I think we may conclude from these results is that for smaller mappings the advantage of the previous approach, although measurable, is wiped out by a single page fault. I think we may expect that there should be at least one access resulting in a page fault (under the previous approach) after making the pages writable, since the program presumably made the pages writable for a reason.

For larger mappings we may guesstimate that the new approach wins if the density of future page faults is > 0.4%. But for the mappings that are large enough for density to matter (not just the absolute number of page faults) it doesn't seem like the increase in mprotect latency would be very large relative to the total mprotect execution time.

So my inclination is that I don't really see a strong need for it to be toggleable, but if we do, the behavior implemented by this patch should be the default. Perhaps something like madvise(MADV_COLD) could be used to get the previous behavior but I wouldn't implement that straight away.

Peter

maintainer
#3 lore raw
Quoted 29 lines · On Mon, 28 Dec 2020 18:09:28 -0800 Peter Collingbourne <[email protected]> wrote:
Quoted 20 lines · Andrew Morton
Quoted 8 lines · On Fri, 11 Dec 2020 21:31:52 -0800 Peter Collingbourne <[email protected]> wrote:

In the Scudo memory allocator [1] we would like to be able to detect use-after-free vulnerabilities involving large allocations by issuing mprotect(PROT_NONE) on the memory region used for the allocation when it is deallocated. Later on, after the memory region has been "quarantined" for a sufficient period of time we would like to be able to use it for another allocation by issuing mprotect(PROT_READ|PROT_WRITE).

Quoted 8 lines

Before this patch, after removing the write protection, any writes to the memory region would result in page faults and entering the copy-on-write code path, even in the usual case where the pages are only referenced by a single PTE, harming performance unnecessarily. Make it so that any pages in anonymous mappings that are only referenced by a single PTE are immediately made writable during the mprotect so that we can avoid the page faults.

Quoted 7 lines

I worry that some other application out there does a similar thing, but only expects to very sparsely write to the area. It will see a big increase in mprotect() latency.

Would it be better to implement this as a separate operation, rather than unconditionally tying it into mprotect()? Say, a new madvise() operation?

Quoted 7 lines

So the case that you're concerned about would be highlighted by this program, correct?

...

So it seems that even with a single page fault the new approach is faster.

Cool, thanks. Can you please roll this new info into the changelog and resend?

#4 lore raw
Quoted 35 lines · Andrew Morton
Quoted 32 lines · On Mon, 28 Dec 2020 18:09:28 -0800 Peter Collingbourne <[email protected]> wrote:
Quoted 20 lines · Andrew Morton
Quoted 8 lines · On Fri, 11 Dec 2020 21:31:52 -0800 Peter Collingbourne <[email protected]> wrote:

In the Scudo memory allocator [1] we would like to be able to detect use-after-free vulnerabilities involving large allocations by issuing mprotect(PROT_NONE) on the memory region used for the allocation when it is deallocated. Later on, after the memory region has been "quarantined" for a sufficient period of time we would like to be able to use it for another allocation by issuing mprotect(PROT_READ|PROT_WRITE).

Quoted 8 lines

Before this patch, after removing the write protection, any writes to the memory region would result in page faults and entering the copy-on-write code path, even in the usual case where the pages are only referenced by a single PTE, harming performance unnecessarily. Make it so that any pages in anonymous mappings that are only referenced by a single PTE are immediately made writable during the mprotect so that we can avoid the page faults.

Quoted 7 lines

I worry that some other application out there does a similar thing, but only expects to very sparsely write to the area. It will see a big increase in mprotect() latency.

Would it be better to implement this as a separate operation, rather than unconditionally tying it into mprotect()? Say, a new madvise() operation?

So the case that you're concerned about would be highlighted by this program, correct?

Quoted 7 lines
Quoted 4 lines

...

So it seems that even with a single page fault the new approach is faster.

Cool, thanks. Can you please roll this new info into the changelog and resend?

Sent a v2 with the new info added to the commit message.

Peter